0
What else can I help you with?
How do you replace a thermostat on a 1994 Acura Legend?
To replace the thermostat in a 1994 Acura Legend you will first need to follow the vehicleÕs radiator hose to the area where it connects to the engine. The area of connection is known as the thermostat housing. Squeeze the two tabs on the radiator hose clamp using a pair of pliers and pull the hose off of the thermostat housing. Remove the bolts which hold the lid to the thermostat housing so the housing can be removed. Remove the thermostat and its gasket from the housing. Clean the mating surfaces of the thermostat housing and lid. Place the new thermostat in the housing and attach the gasket making sure that the spring end of the thermostat sits in the housing and the pin is facing out. Put the lid in place and secure it with the proper bolts. Replace the radiator hose on the thermostat housing and reclamp it.
How do you replace the thermostat located on a 1989 Acura Legend?
The thermostat is located at the back of the engine near where the radiator hoses attach. There is a housing held in by two bolts. It may be necessary to remove the air cleaner housing to access it. The new thermostat from Honda comes with the gasket and can only be installed one way (with the pin up).
How do you replace a thermostat on a 1991 Acura Legend?
Should be located in a removable housing at the engine end of the upper radiator hose Drain about 1 gallon of coolant from the radiator Remove this housing Note how thermostat is installed Clean both surfaces Replace thermostat and gasket Replace housing Re-fill coolant slowly to prevent an air lock Start engine and look for leaks Run engine to normal operating temperature with heater on Re-check coolant level
Where is the thermostat located on a 1995 Acura Legend?
The thermostat is located just below the htrottle linkage at the throttle body. Follow lower radiator hose to engine. It is in the housing at the end of hose.
How to find and replace a 92 Acura Legend thermostat?
how do u find and replace a 92 acura legend thermostat
How do do find the thermostat on a 1998 acura legeng?
To locate the thermostat on a 1998 Acura Legend, first ensure the engine is cool for safety. The thermostat is typically found at the engine end of the upper radiator hose, where it connects to the engine block. You may need to remove the hose and the thermostat housing bolts to access the thermostat itself. Always consult a repair manual for detailed instructions specific to your vehicle model.
How do you replace the thermostat on a 91 Acura Legend coupe?
The way to replace the thermostat on a 91 Acura Legend Coupe is to drain the radiator and remove the throttle and cable box. Remove the top of the radiator hose and the bolts. The thermostat will be inside.
Where is the thermostat located on a 1993 Acura Legend?
trace the lower radiator hose to the engine, that's where the thermostat located.
Where is the thermostat located on a 1990 acura legend it is not where the radiator hose goes into the motor?
Where is the thermostat located on a 1991 Acura Legend with a 6 cylinder engine Should be on the right side, where the lower radiator hose attaches to the engine. To get to this area you have to remove the air-filter box. Locate the elbow to which the lower hose attaches; it is attached with two hex bolts. Drain the coolant, then disconnect the lower hose from the elbow and take out both bolts, and the thermostat is revealed in its 'well'. You may have to use some force to get the old unit out. Pay careful note to how the thermostat is oriented -- there are two little 'ears' that line it up. Be sure to buy a new gasket for the thermostat when you purchase the thermostat (yes, they should sell them together, but often they don't!) and install to match the one you removed. I advise cleaning out the 'well', the seating face against which the thermostat's valve acts, and the mating face of the elbow casting you removed. I also think it a good idea to blow things out with a good brake or carburetor cleaner, then wipe and let dry. Seat the thermostat carefully in the well - it goes in with the spring facing into the engine, but it really only fits one way - being sure the 'ears' are lined up and the gasket seats all the way into the 'well' with no particles or crud behind it. When reattaching the elbow, be careful not to pinch the gasket. I used a little form-a-gasket around the edge of the joint just to be sure I won't see a leak if the gasket doesn't seat quite right.
Where is thermostat located at in a 1990 Acura Legend?
thermostat help fan come on when the car is runnning, keep the engine from over heating
Are they changing the legal drinking age to 25?
No! This is an urban legend.
What cause a Acura Legend to get hot has new radieator?
Bad thermostat, air bubbles in the line, cooling fan relays not working, or the worst, bad head gasket. You can tell if it's a bad head gasket by white smoke coming out of the tailpipe, brown, sand-like gunk in the old radiator (and possibly new one) and oil mixing with your coolant. Does your heater still work? If not, there's likely a bad thermostat or air bubbles in the line. Make sure you reconnected all coolant temperature sensors. There is one in the radiator.
