yes
it does
Brake bleeder? Clutch bleeder? Coolant bleeder?
Where is the coolant bleeder valve located on a 2003 nissan maxima 3.5
The bleeder valve in right on the slave cylinder, no idea how to open it though, it's all plastics and no screws
where is the bleeder valve for 2003 Saturn ion clutch
To refill the coolant on a 2003 Range Rover, use the filler tower that is located on the heater hose. Open the valve and pour in the coolant. Run the car for a short time, then top off the coolant after any air in the system has had a chance to be pumped out. Close the valve again to complete the job.
its on the driverside of radiator. Near the bottom. just a plastic pipcock.
Probably a 10mm. A six point would be best.
Have a helper pump the clutch pedal several times then hold it down. On the slave cylinder, loosen the bleeder valve until fluid starts to flow. When the fluid stops, snug the valve up and have the helper pump the pedal again and repeat the process. When the fluid comes out with no air mixed in it, close the bleeder valve tightly and the process is complete.
Remove the wheel, the bleeder screws are on the inside on top of the caliper.
Just drain the rad at the petcock (little valve on bottom) & fill w/50/50 mix.
All cars have a valve like a tire valve you just plug into to recharge. You can buy a can of r12 at any auto parts store and instructions will be on can.
Sounds like you may have a bad head gasket.It will leak exhaust into the cooling system and create alot of pressure