0
What else can I help you with?
What is a proper idle speed for toyota camry 2001?
Once the engine warms up it should be in between 600-800 rpms.
What is the correct fuel pressure for a 1992 Toyota Camry le with a 2.2L engine?
13-20 psi at engine idle 23-31 psi key on engine off
How do you adjust idle on 2003 Toyota Camry?
You can't. Toyota Camry uses throttle position sensor to adjust idle. If your car does not idle you need to check computer for error codes. If you do not have any, most likely you will have to do tune up on your engine and maybe even fuel system. But starters check the air filter and replace if you did not do that in a while or if it looks dirty.
Why does my 1990 Toyota Camry idle fast a start up?
This is because the engine has not yet fully warmed up. The computer increases the idle speed to prevent stalling when the engine is cold. To correct this, wait for the engine to warm up, or shut it off.
Why would a 1992 Toyota Camry idle very high?
May be throttle plate stuck--with engine off try to "free" up with screwdriver
What could be the cause hard to start 1993 Toyota Camry 4cylnder when engine cranks but often will not start?
Its old, google how to clean (ICV) idle control valve.
Vibration in front of engine at idle 2004 Camry?
car run good but has a little vibration idle or running
1996 Toyota Camry will start but wont stay running on its own?
Check the idle sensor if you have one.
Where is the idle air control valve located on a 2000 Toyota Camry?
Connected to, and under ther Throttle body. Go to YouTube and type IAC on 2000 Camry.
1990 Toyota Camry with a rough idle?
I have 200,+ miles on the car. I change the plugs and wires yet it runs rough at idle and runs smooth at crusing speed. What can i do?
Would a bad starter cause a 1995 Toyota Camry to have a loud idle and now car wont start at all?
Loud idle? no, not turn over ,yes
Why a 1992 Toyota Camry turnoff when you stop?
Most likely because it can't idle. You need to check if the idle control valve is working (if you have one), also try adjusting the idle control screw.
