How do I program key fob for 2006 Toyota solara?

Answer 1

You should check this site: http://www.keylessride.com They have had the key fobs I have needed so far and at great prices.

GadgetJQ Adds:

I'll assume you already have a fob that's proper for your car. Try this (it helps to have one person reading the instructions while the other follows them). There are two programming methods. Usually the first works for Gen II Solara but if not try method II:

Method I

1. Start with the following conditions: You are in the drivers seat.

a. Key is out of the ignition

b. Driver door is open (all other doors closed)

c. Driver door is unlocked (other doors don't matter)

2. Insert and remove the key from the ignition twice within 5 seconds.

3. Close and open the drivers door twice within 40 seconds.

4. Insert the key into the ignition and remove it.

5. Close and open the drivers door twice within 40 seconds.

6. Insert the key into the ignition.

7. Close the door

8. Turn the key in the ignition on and then off.

9. Remove the key from the ignition.

10. The power locks should automatically cycle once to indicate that you have successfully entered program mode.

11. Within 40 seconds of the entering program mode.

a. press both transmitter lock and unlock buttons SIMULTANEOUSLY for a duration of from 1 to 1.5 seconds.

b. within 3 seconds, press the transmitter lock button for more than 1 second and release.

c. If the transmitter has been sucessfully programmed, the power locks will automatically cycle once. If they cycle twice, the remote has not been accepted.

d. If multiple remotes are to be programmed, repeat steps A-C.

12. Open the driver's door.

Method II

1. Start with the following conditions: you are seated in the vehicle

a. Key is out of the ignition.

b. Drivers door is open, all other doors are closed.

c. Drivers door is unlocked.

2. Insert the key into the ignition (don't turn it) and pull it out.

3. Perform these steps within 40 seconds:

a. cycle the power locks 5 times, evenly spaced and relatively fast.

b. Close, then open the drivers door.

4. Perform these steps within 40 seconds:

a. cycle the power door locks 5 times. (Same as before)

b. Turn the ignition to on, then back to off.

c. Turn the ignition to on, then back to off.

d. Remove the key from the ignition.

5. Within 3 seconds, the power door locks should cycle (automatically) indicating successful entry into programming mode. Return to STEP 1 if the locks do not cycle at this point.

6. Perform these steps within 40 seconds:

a. Press the lock and unlock buttons on the transmitter simultaneously for 1 second.

b. Immediately after letting go of the lock and unlock buttons, press the lock button by itself and hold for 2 seconds. Within 3 seconds, the door locks should cycle once indicating successful programming. If the door locks don't cycle, or cycle twice, repeat steps 6a and 6b - this remote has not been accepted.

c. Repeat steps 6a and 6b for each transmitter that will operate this vehicle, including any old transmitters.

7. Close the driver door.