answersLogoWhite

0

The dealers scan tool is required.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you program a new fob for 2002 Jeep Liberty limited if you do not have a fob to program from?

So far its pay the Dealer $68.There got to be a salesman out there who knows and would answer this for a car buyer referal.


How do you program a key fob to a 2006 Chevy Malibu?

How do you program a key fob to a 2003 Chevy Malibu


How do you program a 2008 Jeep Patriot fob?

A scan tool is required.


How do you program new key fob 2006 Chrysler town and country?

A scan tool is required to program a fob on a 2006 Chrysler Town and Country.


How do you program a keyless entry fob for a Jeep Grand Cherokee?

it has to be done by the dealer. =(


How do you program a key fob for a 1994 Jeep Grand Cherokee?

I have a jeep 1994 Jeep Grand Cherokee and found this answer on this site under programing a 1995 jeep Grand Cherokee. Its a very good description uses the same FOB.


How do you program the key fob for the 1999 Jeep Cherokee?

Dealer only on 96+ newer Jeep Grand Cherokee's


Key fob 2009 Jeep Wrangler?

Available at the dealer, he will have to program it.Available at the dealer, he will have to program it.


How do you program the key fob for the 1999 Jeep Grand Cherokee?

Dealer only on 96+ newer Jeep Grand Cherokee's


Cost to replace 2002 jeep liberty key?

Just had (Nov 2008) my key and fob replaced by dealership in West Lebanon NH. Cost $52.90 for the Key Blank, $64.30 for the FOB Transmitter, and $25.50 labor to cut key and program the fob, for a total of $142.70 plus about 1 hr drive time and wait time at the dealership.


What size battery is in the key fob of a 2006 jeep commander?

The key fob for a 2006 Jeep Commander typically uses a CR2032 battery. This is a 3-volt lithium coin cell battery, which is commonly used in various key fobs and electronic devices. To replace it, you can usually open the key fob with a small screwdriver and swap out the old battery for a new one.


How do you program a 1998 Jeep Grand Cherokee alarm to chirp?

I believe you have to take it to a Jeep dealership & they can program it. If you keep pressing the unlock button on your key fob (about four times) it will start chirping. The same for locking.

Trending Questions
Where are the timing marks for a 1.3L 4cylinder 1996 Chevy Metro? How do you recharge the ac in a 2000 chrysler concorde? How do I removed the starter from my 92 Chevy S10 4wd pu 4.3 Ltr since I don't have enough room to remove it even after the bolts are loose? Why does Ford Duratech 2.5 runs rough and check engine light on. I cleaned idle air control valve. Mooseing has stopped but engine still misses and check coolant light is on. The coolant level is fine? What type of oil does a 1999 jeep wrangler use? What does t in Model T stand for? How do you reset the brake pad sensor light on a Chevy Express van? How do you release the fuel pressure on a 1990 Chevy Camaro? When I put my 96 sable into drive the radio and power steering go out. Someone says it is a shift sensor gone bad. How do you replace shift sensor? Why is oil only getting to one side of rocker arms? How do you replace pwoer window fuse on 1997 Monte Carlo? Where is the computer on a 1998 Ford F-150 4.2L located on this truck? Where it's the knock sensor located on 91 Ford Taurus? Do I need to change front impact sensor on a 2000 Tahoe after bag deplored? Where can you find the schematics for a 2001 Jeep Grand Cherokee Larado cooling fan so that you can locate the solid state relay for the fan? Where is the cabin air intake for 1997 Chevy 1500? Where is the blower fan motor resistor on a 1992 Olds 88 Royale? What are engine codes 41 and 25 FOR A 91 DODGE SPIRIT? Why will not 2002 dodge will not go into park? How much freon to put in 1998 5.4 expedition?