you usually replace the entire compressor. Before doing that make sure your low pressure switch isn't faulty.
To replace the AC clutch discharge the freon, remove the clips, and remove the screws under the bumper. Remove the driver side headlight, and bolts.
no, unless u have to remove the compressor unit. The clutch can be replaced with out removing the compressor if you have room to do it.
They require a puller.
This requires special tools to remove and install the ac clutch and bearing. The air gap on the ac clutch must be done during install.
the Clutch is not fully disengaged. compressor might need to be replaced. I would bring it to the shop. Look at the Compressor and if u notice shavings then it has done its duty. If you do not want the AC anymore and want a cheap fix. Just go to a AC shop and get them to remove the clutch. the Clutch is not fully disengaged. compressor might need to be replaced. I would bring it to the shop. Look at the Compressor and if u notice shavings then it has done its duty. If you do not want the AC anymore and want a cheap fix. Just go to a AC shop and get them to remove the clutch.
To remove the AC clutch on a 1986 Chevy van G-20, first, disconnect the battery and discharge the AC system safely. Then, remove the serpentine belt by loosening the tensioner. Next, unbolt the AC compressor from its mounting bracket and disconnect the electrical connector. Finally, use a clutch removal tool to detach the clutch from the compressor shaft.
You need a Z7 Clutch puller.
How do i remove an air compresser in a GMC Cheyene
The AC Clutch on that year truck is conected to the compressor, Unfortunately there is no way to separate the both. You must pick up a new compressor if your clutch has failed...
To change the AC compressor clutch on a 2001 Peterbilt, first, disconnect the battery and remove the serpentine belt from the AC compressor. Next, remove the compressor from its mounting bracket to access the clutch assembly. Use a puller tool to detach the clutch from the compressor shaft, then install the new clutch by reversing the removal process. Finally, reassemble everything, reconnect the battery, and check the AC system for proper operation.
AC Compressor clutch relay may be stuck. Remove the relay and see if the clutch releases.
You needa specialtool to remove it and install it. You will need to measure the air gap between the clutch plate and pulley as you install it, .010" to .015" will usually do it.