0
This is to change a fog light for 2002 outback sport. The light is quite large and would be considered at rally light. What needs to be done is purchase the light from any parts supply store. Get the impreza bulb and not the outback bulb. Under the car there is 2 layers of plastic you need to go through to get to the light from underneath. Remove the plastic pins and clips of the plastic so you can reach up to the light. There is a cap that holds the bulb in place. Unscrew the large plastic cap and you have some wiring come out of a little white piece that is clipped into the plastic cap. Take a screw driver or pliers and pop out this connection. You will notice a white wire coming out of one end of the white piece that was clipped in. This white piece is connected the the bulb you are replacing. Now comes the tricky part of removing the bulb. There is a piece of wire that locks the light in place that needs to be unclipped. Find the end of the wire which is the hindge and follow with your hand to the other end. This takes some fiddling around but this end will become loose and release the bulb. Switch the bulbs and now work backwards.
What else can I help you with?
How do you change the park light on a subaru impreza?
To change the park light on a Subaru Impreza prop the trunk lid open and locate the taillight housing. Remove the plastic cover and the bulbs for the parking lights. Replace the bulbs.
How do you reset the oil change light Subaru Outback you?
A person can reset the oil change light on the Subaru Outback by turning off the vehicle and disconnecting the battery. Also, it is important to check the oil level just in case there is an issue.
Where is the tail light fuse panel for subaru impreza wrx located?
The tail light fuse panel for the Subaru Impreza WRX located in the fuse box.
How do you fix Subaru Impreza Reverse light?
Replace the bulb
Your Subaru impreza wrx 1995 engine light came on after you washed the engine why?
why the engine light of my subaru came on after i washed the engine
Where is the ECM reset button on a 1999 Subaru Outback Impreza?
There is no reset button. The computer is reset by repairing whatever tripped the CE light, and then using a scan tool to reset the light. Reset the light without repairing the problem and the light will just come back on.
How do you replace the park light of a 1993 Subaru impreza?
Purchase a new one
Have Subaru Outback a back-up light relay?
Yes, it have none
How do you replace a side marker bulbs on a 2002 subaru impreza outback sport?
To replace the side marker bulbs on a 2002 Subaru Impreza Outback Sport, first, locate the side marker light assembly on the front fender. Gently pull the assembly out by pressing the retaining tab and disconnect the electrical connector. Twist the bulb socket counterclockwise to remove it, then replace the old bulb with a new one. Reassemble by reversing the steps, ensuring everything is securely in place.
How do you reset oil light on Subaru impreza?
To reset the oil light on a Subaru Impreza, turn the ignition to the "ON" position without starting the engine. Then, press and hold the trip reset button on the dashboard until the oil light blinks and then turns off. Release the button, and the oil light should remain off. If the light reappears, it may indicate that an oil change is still needed or there's another issue.
Where is the DRL module on a 2000 Subaru Impreza?
The daytime running light (DRL) module on a 2000 Subaru Impreza is located in the engine compartment. It is on the right side as you are facing the windshield near the main fuse box.
How do you change tail light on 2006 Subaru Outback?
See "Rear Combination Lights" on page 51 in chapter 11 "Maintenance and Service" of your "OWNER'S MANUAL".....
