answersLogoWhite

0

There is no reset button. The computer is reset by repairing whatever tripped the CE light, and then using a scan tool to reset the light. Reset the light without repairing the problem and the light will just come back on.

User Avatar

Wiki User

20y ago

What else can I help you with?

Related Questions

Where is computer reset button located on a 98 subaru impreza outback?

There is no reset button. Disconnect the battery for a few hours, then reconnect and the computer's memory will be erased. You'll have to reprogram your radio setting.


Is there a reset button on 2003 Subaru Outback?

where is black reset button umder drivers dash


How do you reset 1999 Subaru Outback alarm?

find the reset button under the drivers dash, its atached to two brown wires. once you've found the button turn the key on and hold the button at the same time. this will reset the system and stop the lights from flashing.


Where is the reset button on 1997 Subaru Impreza?

On a 1997 Subaru Impreza, the reset button for the check engine light is typically located under the dashboard, near the driver's side. It may be a small button or a diagnostic connector that requires a paperclip or similar tool to short the terminals. Consult your owner's manual for specific instructions on resetting the check engine light, as the exact location can vary slightly based on the model.


How do you reset vdc off light in subaru 2001 outback?

Try holding the "VDC off" button down for 10 seconds. Not sure, but worth a try. I think I might reset when you start up again.


Subaru impreza fuel pump inertia reset location?

The Subaru Impreza does not have a fuel pump inertia switch. If you are having fuel issues it could be the fuel pump relay or fuel pump.


How do you reset the oil change light Subaru Outback you?

A person can reset the oil change light on the Subaru Outback by turning off the vehicle and disconnecting the battery. Also, it is important to check the oil level just in case there is an issue.


How do you Reset Auto Door Locks on a 1998 Subaru Outback?

How do you reset the auto locks on a 1998 Subaru. Disconnected the battery to clean terminals. Now the auto lock does not work from the door switches


How do you shut off alarm on 04 Subaru Outback?

To shut off the alarm on a 2004 Subaru Outback, you can typically press the unlock button on your key fob. If you don't have the key fob, inserting the key into the driver's door and turning it to unlock should also deactivate the alarm. If the alarm continues to sound, turning the ignition on and off may help reset it.


Why are my parking lights flashing after a battery change in a Subaru Outback 1996?

There is a small black button hanging down just above gas peddel under your dash to reset this problem. You have to hold it in till you hear all the door locks reset ,then your lights will stop flashing.


Is there a computer reset button on 2000 Subaru Outback?

No, there is not. Most code readers will allow you to reset the check engine light, but you can reset it simply by disconnecting one battery terminal and touching it to the other to discharge capacitors in the system. If this makes you nervous, just pull a battery terminal and leave it disconnected for 45 minutes or so. When you reconnect it, the computer will be reset.


How do you reset oil minder on 2013 Subaru outback?

To reset the oil minder on a 2013 Subaru Outback, first turn on the ignition without starting the engine. Then, press the "Gas" and "Brake" pedals simultaneously three times. After that, turn the ignition off and then back on to verify that the oil change reminder has been reset. If done correctly, the oil change light should no longer be illuminated.