0
No, there is not. Most code readers will allow you to reset the check engine light, but you can reset it simply by disconnecting one battery terminal and touching it to the other to discharge capacitors in the system. If this makes you nervous, just pull a battery terminal and leave it disconnected for 45 minutes or so. When you reconnect it, the computer will be reset.
What else can I help you with?
Is there a reset button on 2003 Subaru Outback?
where is black reset button umder drivers dash
Where is computer reset button located on a 98 subaru impreza outback?
There is no reset button. Disconnect the battery for a few hours, then reconnect and the computer's memory will be erased. You'll have to reprogram your radio setting.
Where is the ECM reset button on a 1999 Subaru Outback Impreza?
There is no reset button. The computer is reset by repairing whatever tripped the CE light, and then using a scan tool to reset the light. Reset the light without repairing the problem and the light will just come back on.
How do you reset 1999 Subaru Outback alarm?
find the reset button under the drivers dash, its atached to two brown wires. once you've found the button turn the key on and hold the button at the same time. this will reset the system and stop the lights from flashing.
Where is the security reset buuton on 1998 Subaru Outback?
The security reset button on a 1998 Subaru Outback is typically located under the dashboard, near the driver's side, or on the side of the center console. It may be a small, red or black button that is sometimes hidden behind a panel. If you're having trouble locating it, consulting the owner's manual can provide more specific guidance.
Does the Subaru outback have to have the computer reset in the factory?
If you mean the diagnostic computer (the thing that makes the "check engine" light come on), then no - any dealership should be able to reset this, or you can do it yourself if you buy an OBDII hand-held computer (about $35 on Amazon).
How do i reset onboard computer for 97 Subaru Outback?
To reset the onboard computer of a 1997 Subaru Outback, disconnect the negative battery cable and let it sit for about 15 minutes. This will clear the memory and reset the onboard diagnostics. After reconnecting the cable, turn the ignition to the "On" position without starting the engine for a few seconds, then start the vehicle. Keep in mind that this may also reset other settings, so you may need to reprogram your radio and clock.
How do you reset vdc off light in subaru 2001 outback?
Try holding the "VDC off" button down for 10 seconds. Not sure, but worth a try. I think I might reset when you start up again.
How do you reset the oil change light Subaru Outback you?
A person can reset the oil change light on the Subaru Outback by turning off the vehicle and disconnecting the battery. Also, it is important to check the oil level just in case there is an issue.
How do you Reset Auto Door Locks on a 1998 Subaru Outback?
How do you reset the auto locks on a 1998 Subaru. Disconnected the battery to clean terminals. Now the auto lock does not work from the door switches
How do you shut off alarm on 04 Subaru Outback?
To shut off the alarm on a 2004 Subaru Outback, you can typically press the unlock button on your key fob. If you don't have the key fob, inserting the key into the driver's door and turning it to unlock should also deactivate the alarm. If the alarm continues to sound, turning the ignition on and off may help reset it.
Where is the computer reset button on a 2002 sonata?
No such button.
