left side you should have enough room to get your hand in there right side he have to remove throttle assembly and bracket that gives you just enough room to get it out
No
In a 2004 Mitsubishi Lancer replacing the rear light bulb is relatively easy. First remove the plastic cover from the dome light. Unscrew the light bulb and insert the replacement.
On my 04 Camry that means it's time for an oil change.
To change the bumper-mounted marker light bulb on a 2004 Saab 9-3, first, locate the access panel behind the bumper. Remove any screws or clips securing the panel to expose the bulb holder. Twist the bulb holder counterclockwise to detach it, replace the old bulb with a new one, and then reassemble everything by reversing the steps. Ensure the new bulb is securely in place before closing the access panel.
Write the date and mileage on a small sticker and cover the light with it.
Bottom of the engine next to the drain plug
YES , according to the Gates website , the 2.0 liter 4 cylinder in a 2004 Mitsubishi Lancer is an interference engine ( turbo , non turbo , with and without a balance shaft )
First off, its a chain, NOT a belt, and you DONT change it unless it breaks. You can SET the timing, but you dont have to change the chain. You need a timing light to re-set it if its off. Its like a strobe light.
How do I change the side/parkinglight on a bmw 530d 04 reg Do I have to take the cluster out?
In North America 04-06 and 09-present
The bulbs you speak of have two filaments, one is the signal and the other is the parking light. Could be the parking light filaments are burned out in those two bulbs. Also check all the fuses
noise, vibration, grease leaking & if long enough it can cause severe damage