answersLogoWhite

0

Disconnect motor mounts from block, drain pan, lift by balancer a few inches to clear pan. Front & rear crank seals are tricky. This is not a job for inexperienced.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Will a Subaru legacy 2.5 GT motor bolt up to a 2.2 Subaru Outback?

the motor will bolt up, compression ratio will change unless you get a cometic head gasket that is matching for both.


How do you change the head gasket of a 1995 Subaru Legacy?

I have no clue, but it sounds tricky


How do you change the water pump in a 1998 subaru legacy outback?

To change the water pump in a 1998 Subaru Legacy Outback, start by disconnecting the negative battery terminal and draining the coolant. Remove the timing belt covers, then loosen and remove the timing belt by marking the belt's position for reinstallation. Next, unbolt the water pump from the engine block, clean the mounting surface, and install the new pump with a new gasket. Finally, reassemble everything in reverse order, refill the coolant, and check for leaks.


Why does the 98 subaru impreza outback overheat?

You may need to replace the radiator thermostat and gasket.


How much does it cost to have the head gasket replaced on a 2000 Subaru Outback?

I just got a quote from my subaru dealer for a 2002 outback wagon with the 2.5 engine, and it's $1750. Check to make sure you aren't covered under the recall. If you aren't......I had head gasket, timing belt, and drive belts all replaced for about $1100.00 on my 02 outback wagon. At the dealership.


How much does a catalytic converter cost for a 2006 Subaru Outback?

The new catalytic converter and gasket for my 2005 outback wagon was $830 installed at an independent Subaru specialist. Are you sure that yours is not covered under warranty (80,000 miles, I think)


Why is there gas in the radiator in a 1991 subaru legacy?

head gasket blown. reface the cylinder head and replace gasket. that should fix the problem


Change valve cover gasket on a 2001 outback 3.0 H6?

sure


Were is the oil pan gasket locatedon a 1999 subaru legacy?

The oil pan is at the very bottom of the engine. The gasket sits between the oil pan and the bottom of the block.


What causes a 1998 subaru outback lose power on hills?

You may have a blown head gasket.. Check the coolant overflow for oily, black residue.


How can I fix a 1996 Subaru Legacy Outback with overheating issues Radiator replaced 4 months ago thermostat replaced 3 times Mechanic has ruled out blown head gasket and faulty water pump?

Same problem turned out to be a hair line fracture to the head!


Is there a Picture of thermostat in 2001 Subaru Outback?

Go to: http://opposedforces.com/parts/legacy/us_b12/ Select Body Style, Engine Type, Transmission, etc. Go to Cooling System. Select Water Pump; You should find Thermostat, Gasket & applicable part numbers...