You have to 1st remove th Headlight bc th ballast is attached underneath th headlight...
To remove th headlight, there is a bolt that has to be removed b4 th headlights assembly will even com out. You actually have to go up frm underneath th car. Th bolt needed removing is closest to th wheelwell...to get to it, just remove th corner part of th mudflap..Under th far corner of either side of th front bumper..(You Don't have to take out th Wheelwell plastic casing!) Just to th rght or left corner of th far bumper ...there are two screws, and 3 plastic rivet you need to remove ...thn pull back th plastic cover, and look upwards twds th end of th headlight and you can feel and sorta see th 10 mm bolt you need to remove...once u hav removed this bolt th headlights will easily detach frm th car frame...
Th Ballast is attached directly under th headlight, so disconnect th bulb plugs and pull out unit.. and Wal~Laa th ballast is finally exposed.. there are 3 philliphead screws holding it in place. Good luck :) ~ Megs
how do you change front headlight bulb on 2000 volkswagon cabrio
It does not have a ballast resistor.It does not have a ballast resistor.
For the 1994 model (B3000), you can't change just the bulb. You have to change the headlight assembly.
== ==
How do I remove the headlight unit on a V6 TDI Passat year 2000?
If you look in your owners manual there are step by step instructions on how to properly change the headlight bulbs in your truck.
there are two tabs on the top of the headlight that you need to pull up i the air they you can remove the hole headlight and the bulb twist out of the headlight
Open the hood of the engine compartment. Remove the wiring harness from the headlight. Remove the retaining bolts from the headlight assembly. The headlight unit will come out. Reverse the process to install the new headlight.
USE TEH INTERNET! =D <3
To change the headlight on your 2000 Toyota 4Runner you would need to remove the grille, and then the side marker lights. Then there are 4 10MM bolts that need to be removed in order to take the headlight out. We have also included a how to video in the related links section below, so that you can see how this is done.
To change the headlight socket on a 2000 Volvo V40, first, disconnect the negative battery terminal to ensure safety. Remove the headlight assembly by unscrewing the retaining screws and pulling it out. Then, disconnect the old socket from the headlight bulb and replace it with a new socket by securing it in place. Reassemble the headlight assembly, reconnect the battery, and test the new socket to ensure it works properly.
The headlight assembly on a 2000 Acura Integra is held on using bracket bolts. Prop the hood open and locate the headlights. Unbolt the brackets and remove them. Carefully pry the headlight assembly out to not harm the weatherstripping.