# Unplug the electrical connector from the backside of the bulb # Pull the rubber cap and bulb assembly from the back of the headlight lens # Detach the retaining ring then push straight on the back of the rubber cap and dislodge the bulb from the rubber cap. # Remove bulb
To change the light bulb on a Nissan Micra first lift the hood of the car. Find the headlight housings the pull the light bulbs from the ballast. Replace the bulbs.
To replace the headlight bulb in a 1994 Nissan Sentra first prop the hood of the car. Locate the headlights and remove the bulbs from the housing. Install the new bulbs.
If you look in your owners manual there are step by step instructions on how to properly change the headlight bulbs in your truck.
Nicole
To change a headlight on a 1999 Acura TL open the hood and locate the bulbs which are plugged into the housings. Loosen the bulbs and pull them off. Replace them.
Before replacing the headlight bulbs on a 1997 Acura CL prop the hood open. Locate the headlight housing and remove the old bulbs. Install the new lights.
Faulty bulbs, faulty switch, faulty wiring, disconnected ground.
The headlight assembly (aka the headlight bucket) is removable by releasing the lock tabs behind the assembly. Once the assembly is wiggled out in the open you can easily replace the bulbs.
should be owner manual but part store can look it up
1. Open the hood of your Maxima and locate the headlight assembly. Access to the bulbs is from the backside of the headlight assembly. 2. Remove the electrical connector from the back of the headlight bulb after pressing the locking tab to release it. Pull the connector straight off and set it aside. 3. Locate the locking ring on the back of the headlight assembly and turn it counterclockwise to unlock it. Remove the ring from the assembly pull the bulb out of the headlight. Discard the old bulb and insert a new 9004 halogen bulb into the headlight assembly. 4. Install the locking ring over the bulb and turn the ring clockwise until it locks in place. Plug the wiring harness connector into the back of the new headlight bulb, making sure it snaps onto the locking tab on the headlight.
LIFT THE CLIPS AND PULL IT OUT
You need three Polocks!