You cant chance the spark plugs with out removing the manifold sorry dude i have tried every possible way there is and its not going to happen :(
how to change a spare tire on a hyundai tiburon
tiburon 2.0 Intake air temperature (IAT) sensor lokation?
To reset the oil change sensor on a Hyundai Tiburon, first, turn the ignition key to the "On" position without starting the engine. Then, press the gas pedal three times within ten seconds. After doing this, the oil change light should reset. Finally, turn off the ignition and start the engine to confirm that the light has been cleared.
The Hyundai beta motor has not seen much change in 13 or so years it has been around the starters should be interchangeable.
Owners manual says: with filter change 4.5 U.S. qts. (4.3 liter) without filter - 4.2 U.S. qts. (4.0 liter)
No you don't the fuel filter is under the hood on the driver side.
To change the temperature display to Fahrenheit in a Hyundai Tiburon, locate the climate control unit. Look for the "F" and "C" buttons, which are usually near the temperature settings. Press the "F" button to switch the display to Fahrenheit. If there is no dedicated button, refer to the owner's manual for specific instructions related to your model year.
They have a timing belt they usually recomend to change it every 50,000 miles. other wise it could more expensive
My car 2007 is a four cylinder Hyundai sonata Is there any truth to what the service manager said about having to remove the manifold to change the spark plugs?
depending on how hard you drive your car and the type of oil you use, you should typically change your oil every 3,000 miles. That's average.
According to the 3 different Hyundai dealerships there is not a turn signal relay on a 2003 tiburon. But it is actually located inside the BCM, if you can trust your self with opening the bcm you can change it yourself. Also if you call the dealer they will tell you that the only solution is to replace the BCM but they are full of it, they say that because it a new unit cost $1100+!
remove the top plastic on the right side of the engine and you will the the stock intake, all you need to do is unclip the box and you will see the filter.