To change the water pump on a 1993 Mazda MX-3 with a 4-cylinder engine, first, disconnect the negative battery terminal and drain the coolant. Remove the drive belts, then take off the timing cover and loosen the timing belt tensioner to remove the timing belt. With the timing belt out of the way, unbolt the old water pump, clean the mating surfaces, and install the new pump with a new gasket. Reassemble in reverse order, ensuring proper alignment of the timing belt and tensioner.
you do nothing
where is the water pump located in Mazda millenia
To change the water pump on a 1996 Mazda 626 you have to follow a few step. First you disconnect the miscombobulater from the alternator valve. Then you take the water pump off and put the new one on. Lastly you re -attach the miscombobulator and the altornator valve. There you have it.
Remove the fuel tank or remove the bed, your choice.
To change the water pump on a 1991 Mazda Miata, first, disconnect the negative battery terminal and drain the coolant. Remove the drive belts, then detach the timing belt cover to access the water pump. Unbolt the old water pump, clean the mating surfaces, and install the new pump with a new gasket. Finally, reassemble the timing cover, reconnect the belts, refill the coolant, and reconnect the battery.
Replacing the 1997 Mazda water pump will cost approximately $300. The water pump will cost about $75 and will require four hours of labor.
To change the water pump on a 2002 Mazda Millenia, first, disconnect the negative battery terminal and drain the coolant. Remove the serpentine belt, and then take off the timing belt covers to access the water pump. Unbolt the water pump, replace it with the new one, and reassemble everything in reverse order, ensuring to refill the coolant and check for leaks. Always consult a repair manual for detailed instructions specific to your vehicle.
No
i have a 1995 madza b2300 truck & i believe that the 94 and 95's are identical. i am trying to remove and replace the water pump. i have all 4 bolts removed but i can't get the water pump off the bracket. thanks
can some one tell me if you can change the gasket on the back of the injection pump on 1983 mazda diesel pickup with out any problems
u
The water pump from Mazda 626 is the same, all part from Mazda 626 work very good in the Kia Credos and Clarus.