use the ignition key to turn to on or to start and the system should reset. I stopped using mine because it would trigger at any time wothout an intrusion
what size speakers fit in a 1989 Toyota cressida
== ==
Yes
mabye u need to make a gear adjustment
10 BTDC but you have to remember to ground the timing adjustment conector in the harness
1986.5-1992 (1987-1993 in Japan) Toyota Supra MkIII (MA70)1989-1992 Toyota Cressida Mark II (MX83)Toyota ChaserToyota Crown
I figure you mean what grade of gas should I put in my cressida? Before I blew my headgasket, my 89 cress took 91 octane, anything else would cause piston knock. [detonation]
The knock Sensor in a 1989-1992 Toyota cressida is located under the intake manifold, closer and under the cold start injecter. Behind the alternater. i had to use a small mirror to see it, or you can put your hand under and search for it. Also look at this tread forum: http://www.toyotanation.com/forum/showthread.php?t=213375 Thanks
To reset the circuit breaker in a 1989 Toyota Cressida, first, locate the breaker, typically found in the fuse box under the dashboard or near the engine compartment. If the breaker has tripped, it may appear discolored or have a visible button. Press the button to reset it. If it continues to trip, there may be an underlying electrical issue that needs to be addressed.
The cold start injecter is located in the middle of the intake manifold with the brake master cly. right in the way
On a 1989 Toyota Cressida, the charcoal canister is typically located near the rear of the vehicle, specifically on the driver's side, close to the fuel tank. It is mounted on the undercarriage or within the wheel well area. You may need to remove some protective covers or panels to access it properly. Always refer to a service manual for detailed diagrams and instructions for your specific model.
my service manual says 10 degrees before tdc on auto models with ac off idle @750