answersLogoWhite

0

The cold start injecter is located in the middle of the intake manifold with the brake master cly. right in the way

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

What size speakers fit a 1989 Toyota Cressida?

what size speakers fit in a 1989 Toyota cressida


Where is the fuel pump located on a 1989 Toyota Cressida?

== ==


How do you remove a 1989 Toyota Cressida fuel pump from the car?

Yes


What is wrong with the 1989 Toyota Cressida overdrive?

mabye u need to make a gear adjustment


Where can you find the knock sensor in a 1989 Toyota Cressida?

The knock Sensor in a 1989-1992 Toyota cressida is located under the intake manifold, closer and under the cold start injecter. Behind the alternater. i had to use a small mirror to see it, or you can put your hand under and search for it. Also look at this tread forum: http://www.toyotanation.com/forum/showthread.php?t=213375 Thanks


What is the timing for a 1989 Toyota Cressida 6 cly?

10 BTDC but you have to remember to ground the timing adjustment conector in the harness


How do you disarm a 1989 Toyota Cressida alarm?

use the ignition key to turn to on or to start and the system should reset. I stopped using mine because it would trigger at any time wothout an intrusion


What cars have a 7mgte engine?

1986.5-1992 (1987-1993 in Japan) Toyota Supra MkIII (MA70)1989-1992 Toyota Cressida Mark II (MX83)Toyota ChaserToyota Crown


How do you flush the radiator in a 1989 Toyota Cressida?

To flush the radiator in a 1989 Toyota Cressida, first ensure the engine is cool and then remove the radiator cap. Drain the old coolant by opening the drain valve at the bottom of the radiator and allowing it to flow into a container. Next, fill the radiator with a mixture of water and a radiator flush product, running the engine for about 10-15 minutes with the heater on to circulate the solution. Finally, drain the flush solution, rinse with clean water, and refill with the appropriate coolant mixture.


What is the gas for 1989 Toyota cressida?

I figure you mean what grade of gas should I put in my cressida? Before I blew my headgasket, my 89 cress took 91 octane, anything else would cause piston knock. [detonation]


Where is the PCV valve on 1989 Toyota 22re?

top of the valve cover closer to the rear with a hose going straight to the EFI


Whats the problem with a 1989 toyota cressida when it runs and then wont start?

Get fast answers to your Toyota Cressida questions from experts in the CarGurus automotive community. ... and piston rings on my automatic Cressida but the crank won't turn please help ... have done all thing related to mthis problem but it is not solved what shoould i do? ... Starts right up, runs for 10-15 min then cuts off.