0
How do you fix a broken speedometer and turn off the hold light on a 1994 Mazda Protege?
Check to see if the wires that go from the hold light down on the shift lever aren't shorting because of the insulation peeling. I had the same thing happen to my 94 Protege but the light started doing that after I whacked the dashboard really hard so I must have messed something up under there. I had the same problem on a 93 Mazda and it was a bad fuse just search for it and put in a new one it will all start to work again. The speed sensor which is located up near the instrument cluster is bad. My 1994 is doing this too, I need to find out if the speed sensor is part of the cluster or if it's a separate item.
What else can I help you with?
If you have a Mazda Protege '91 which has a hold light blinking and the speedometer does not work what is wrong with it?
it could have a bad speed sensor
Mazda Protege gas light?
reset it.
You have a 1992 Mazda Protege hold light remains on?
I suspect your hold switch on the shift lever might be bad..or ahs a broken wire.
Where is the fuse for the tail light aton a Mazda Protege?
Fuse panel.
What does a blinking Hold Light on a 1992 Mazda Protege mean?
tranny problems
What would cause a 1991 Mazda Protege to have a blinking hold light and a non-functional speedometer?
The speedometer cable (which runs from the transmission to the dashboard) has snapped. This is a two-piece cable, and the one-piece cable in later Proteges will not work. I had the transmission replaced, and the cable could never be fit in properly. This is a mechanical speedometer, so you would have to change the entire speedometer part of the instrument panel to use a magnetic/electronic speedometer.
What could be wrong if the speedometer is not working on a 2001 Mazda Protege and the check engine light is on and also the overdrive off light is flashing?
My knee-jerk answer would be a TCM (Transmission Control Module) problem, but have a shop hook up a scan tool and they can tell you what is wrong.
Where is the brake light switch for the 1997 Mazda protege?
Above the brake pedal,its black plastic.
What does the hold light mean on a 1990 Mazda protege mean?
The HOLD light means you have an electrical problem with your transmission. See your mechanic ASAP.
Does the check engine light on a 1998 Mazda Protege have a fuse?
It is run off of the same fuse as the engine computer.
Why does your speedometer only work when your parking brake light is on?
because your car is broken
Your brake light sw is working and your brake lights still remain on for your 1992 Mazda Protege?
Switch is defective or out of adjustment.
