HO2S Heater Control Circuit High (Bank 1 Sensor 2)
symptoms
Other than the MIL light illuminating you may not notice any performance issues.
cause
A short in the O2 sensor heater circuit or the sensor itself
A faulty O2 sensor heater
Wiring or connectors are broken or frayed to the sensor or relay
Bad PCM or ECM
The fix
Correct wiring short or loose connector found in inspection.
and/or
Replace the bank 1 sensor 2, O2 sensor
Replace PCM if circuit has failed and no wiring issues present, good O2 sensor
A 2005 Hyundai Elantra with less than 100,000 miles is still eligible for coverage under the manufacturer's warranty. Transmission slip could be any number of things, but the cheapest fix is to ensure the proper transmission fluid is being used. If the recommended fluid is being used, then the best solution is to take it to the dealership and request a warranty repair.
It was just a wire that was diconnected, go up under the dash board and reconnect it
it is probably the thermostat any one can change one on a Hyundai they cost under $15.00
Umm.. get an front end alignment.. and tires balanced ;)? may be??
could be as cheap as 40 bucks for a flush if its a automatic or a whole new tranny which will be over a 1000.
drive the car into a tree a big one very fast lol
To fix a squealing belt in a 2007 Hyundai Elantra, first, inspect the serpentine belt for signs of wear, cracks, or damage. If it's worn, replace it with a new one. Additionally, check the belt tensioner and pulleys for proper alignment and function; if they are faulty, they may need to be replaced or adjusted. Finally, ensure that any oil or coolant leaks are addressed, as these can contribute to belt slipping and squealing.
go to your Hyundai dealer and make it check
duck tape lots of duck tape
How much does it cost to replace the front bumper on a 2013 hyundai accent
just change it
The cost to fix a crankshaft in a 2005 Hyundai Sonata can vary significantly based on the extent of the damage and local labor rates. Generally, you might expect to pay between $1,500 and $3,000 for parts and labor. If the crankshaft needs replacement, the price could be higher due to the complexity of the job. It's advisable to get quotes from several mechanics for a more accurate estimate.