answersLogoWhite

0

Honda dealership much? ask them

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How do you fix egr in my Honda prelude 2001?

Below is a DIY on cleaning up the Prelude's EGR.


How much it costs to fix timing belt on Honda Prelude?

The cost to fix a timing belt on a Honda Prelude will vary depending on labor costs, parts, and location. On average, prices will start at about $400 to change the timing belt.


How do you fix a 1990 Honda Prelude that idles to high in park?

my 91 Honda prelude 4ws si with 2.1 engine had high idle in park. then my timing belt went put a new belt on hasn't done it yet!!! I do not fix them, I bring it to the dealer and let them fix it.


How do i fix a low idle on a 1986 Honda prelude 2.0 si?

my Honda prelude 1986 si wants to cut off after its warmed up . any sugestions on what ot could be


How do you fix a 1991 prelude?

Fixing a 1991 Honda Prelude varies depends on what exactly is wrong with the car. If there is a CEL take the car to a have a diagnostics test done. This will help narrow down the problem to the source.


2001 Honda Prelude how to fix code p0505?

seek to find code 504 and it will lead you that will help give you further instructions about code505!!.


How do you fix p1491 code Honda prelude 2001?

Could be an EGR port clogged with carbon. Remove and clean EGR and EGR ports.


How to fix the handbrake on my Honda Prelude?

I dont know much about hondas but the handbrake should connect to the rear brakes inspect the area underneath you're prelude to see where it goes and see if the cable is broken or is it is connected etc.


How do you fix the flex pipe on a 1992 Honda Prelude?

replace with a new pipe new gaskets and bolts must torch out old bolts from cat Take it to a muffler shop


How do you fix the malfunction check light on 2002 Honda?

Have vehicle scanned to determine the problem


How do you replace a brake light blub on a 1997 Honda Accord?

you take it apart and fix it


How do you fix a 1993 Honda preludes back quarter panels?

Would i tack weld a peice of quarter panel from another prelude of the same generation and then grind it down, sand, primer, and then paint it?