That is the maintenance required light. With the ignition off, push and hold the odometer reset button and then turn the ignition to the on position but do not start the engine. After a few seconds the light will go out.
The dashboard of a 1985 Honda Civic is held together by a series of mounting screws. To remove the dashboard loosen all of the mounting screws. Pull the remaining clips off and take off the dash.
traction control system When you see that on your dashboard the system is turned off. Turn it back on.
WHAT DOES "SRS" LIGHT ON 2001 HONDA ACCORD DASHBOARD MEAN AND HOW CAN YOU PUT IT OFF
It will go off the second time you startup AFTER fixing the problem it's on for.
The 1994 Honda Camry dashboard is held in place by 12 retaining clips. Pry outward on each retaining clip. The dashboard will come off in three pieces. Reverse the process to install the new dashboard.
To reset the wrench light on a Honda Odyssey after an oil change, turn on the ignition without starting the engine. Press the gas pedal three times within 10 seconds. Then, turn off the ignition. When you start the vehicle again, the wrench light should be reset.
Remove the two Allen bolts at the rear end of the seat with a hex wrench, then slide it back.
To remove the center dashboard on a 2011 Honda Jazz, start by disconnecting the negative battery terminal to ensure safety. Then, use a trim removal tool to carefully pry off the trim surrounding the dashboard area. Remove any screws or clips securing the dashboard in place, and gently pull it away from the frame. Make sure to disconnect any wiring harnesses before fully removing the dashboard.
I believe the size is 14mm (thread size) and you use a 17mm box end wrench or suitable socket to loosen..unless some gorilla with a impact wrench tightens it and use can't get it off..like my 2002 Honda civic EX.
To turn off the passenger airbag in a 2003 Honda S2000, locate the airbag switch, which is typically found on the side of the dashboard near the driver's door. Insert the key into the switch and turn it to the "Off" position. Ensure that you check the dashboard for any indicator lights confirming that the airbag is disabled. Always refer to the owner's manual for specific instructions and safety precautions.
15\16 socket and a impact wrench and a ratchet strap. It has left handsed threads.
To turn off the wrench light on your 2007 Honda Fit, first ensure that any necessary maintenance has been performed. Then, turn the ignition to the "ON" position without starting the engine. Press the gas pedal three times within 10 seconds, and the light should turn off. If the light remains on, you may need to consult your owner's manual or a mechanic for further assistance.