answersLogoWhite

0

alright these are fun.....you have to take off the plastic covers underneath. There should be two torx bolts that are holding in the assembly that you get to from the front. after this reach up from underneath and push out the assembly through the fender. you wont have much room to work on it but its just enough to replace it. Test before putting back together because its a pain trying to get them out. the bulb will have one wire coming from it with a metal slab at the end of it. the slab will slide into what looks like a splice connection. there is a gound wire that will go to the metal flanged washer on the back of the fog light assembly. make sure this is clean and gets a good connection, i had to wiggle mine to get a good connection so it would work. good luck!

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

How do you replace fog lamps on a 1999 Cadillac Catera?

look under the vehicke where the fog lamps are and you will see a rubber housing that fits around the openin gof the fog lamps, Now take off the rubber seal and you will see the mini bulb and alls you have to do is push forward on both of the small springs and it will release and from there you can tak eoff the mini fog lamp bulb.


How do you replace a fog light bulb on a Jeep Liberty?

There is a small square "trap door" in each wheel well directly behind the fog lamps. You can pry it open and access the fog lamps. They just twist loose. Untrue...in the 2008 Liberty in any case.


Why do fog lamps show up more in fog than other lamps?

Fog lamps on a car show up a lot more in the fog than other lamps simple because they are much brighter. It is therefore advised that you only use them in extreme cases of fog as it can cause issues for other drivers if you have your fog lights on when there is little to no fog.


How do you change the fog lamps in a 2009 Chevy aveo LT?

To change the fog lamps in a 2009 Chevy Aveo LT, start by accessing the fog lamp housing, which is located behind the front bumper. You may need to remove the underbody shield or wheel well liner for better access. Once you reach the fog lamp, twist the socket counterclockwise to remove it, then pull out the old bulb and replace it with a new one. Reassemble the parts and test the fog lamps to ensure they are working correctly.


How do you turn on the fog lamps on a 1997 Town and country?

On my 2000 town and country, you pull out the headlight switch, fog lamps only work on low beam On my 2000 town and country, you pull out the headlight switch, fog lamps only work on low beam On my 2000 town and country, you pull out the headlight switch, fog lamps only work on low beam


Replacing fog lamps on 1997 olds lss?

Replacing a fog lamp on 1997 Olds LSS is easy. All you have to do is take the lights out of the car, take the old bulb out than replace it with the new one.


How do you install new fog lamps on Ford Mondeo not equipped with fog lamps?

Take a look here, if your Ford is a MK2. http://www.fordmondeo.org/wiki/index.php/Fog_Lights_-_Mk2


What bulb size are the fog lamps for a 2001 Ford F-150?

According to the 2001 Ford F-150 Owner Guide : The Fog Lamps take bulb ( # 9145 )


What if your bumper have opening but no fog lights Xl7?

it will still pass inspection but it is better to buy the fog lamps


The maximum number of fog lamps you may have on your vehicle is?

4


Which metal vapour is used in fog lamps?

Probably sodium.


What number is the fuse for the fog lamps on Mercedes c320?

69