answersLogoWhite

0

If the buckle is made from a ferrous metal, it will be attracted to a magnet. Attach a magnet to an appropriate spot to store/hold the buckle and voila!

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you use a belt buckle?

The belt usually has a clip or ring that is on the left side (as it's worn) of the belt buckle. Before putting the belt on, put the length of the belt through that clip, then put the belt on. The small nub you'll find on the right side (as it's worn) of the belt buckle will go into a free hole to keep the belt buckle in place. If you have a detachable belt buckle such as a western belt, then the belt and the buckle are sold separately. If that is the case, then the belt will have a snap that will open the end. The buckle has a metal ring on the inside that the end of the belt will go through.


Why does the timing belt keep slipping?

Either the belt is worn out, incorrect belt, drive gears are worn, or the tensioner is defective.


Does the butt of the golf club point at your belt buckle on all shots at address?

For me, the butt end points just left of the belt buckle at address. For you, however, you need to determine if you do better with it pointing at the belt buckle or slightly left of it (right hander, of course). Keep golf simple, and good luck.


What do I need for my pool aerobics class?

You need water slippers to keep from slipping on the bottom of the pool floor.


How do we keep the dryer belt from slipping of the pulley?

Make sure the cable is Secure, and or you can push harder than usual.


Why it is necessary to keep the bathroom floor clean and free of oily substances?

Yes, it is. Your barefeet touch the floor, so you have reason to not want it dirty, or able to be slipped on.


What is the best way to dance with a girl two feet shorter than you?

Keep your distance. No girl likes to talk to some guys belt buckle.


What is that thing that santa has on his belt?

The popular idea of Santa Claus has him wearing a heavy Black Garrison belt with a gold or brass buckle over his costume, to keep it on - the Garrison belt is used for the same purpose on a trench coat. along with Boots, it has a transportation orientation.


Why does power streering belt keep breaking on 1996 Mazda Protege?

The Pulley is slipping forward during pump engagement and tightening the belt to breaking point. Tighten or replace bolts holding power steering pump to the bracket. I have been hearing a pulley that sounded loose or like it was gonna fail and have been waiting on the serpentine belt to break on 1996 Mazda protege. Will I feel that the pulley is slipping?


How do you disable the seat belt alarm on a 2006 ford 15 passenger van?

To disable the seat belt alarm on a 2006 Ford 15 passenger van, you can buckle and unbuckle the seat belt multiple times in a specific sequence. Start by buckling the driver's seat belt, then unbuckle it and buckle it again three times within about 10 seconds. This should disable the alarm. However, keep in mind that disabling the seat belt alarm can compromise safety, so it’s generally recommended to use seat belts properly.


How do you disable the seat belt alarm on a 2008 Ford Falcon?

To disable the seat belt alarm on a 2008 Ford Falcon, you can often do so by buckling and unbuckling the seat belt multiple times in quick succession. Typically, you would buckle it three times and then unbuckle it three times to reset the system. Alternatively, you can consult the vehicle's manual for specific instructions or consider using a seat belt buckle extender. Keep in mind that disabling safety features can compromise safety.


How do you connect usmc white web belt to the buckle?

Ok...here we go. you should have a brass buckle, one hook, two smaller brass "keepers" and one 2" white belt. For starters the buckle goes on your right side. This will be obvious when You pick up Corporal, but its good to get in the habit now. 1:With the buckle face down, and slide the white belt into the bent-over tab with the hole. 2:slide one of the "keepers" down the end of the belt that just went through the hole. 3:fold the belt back over and run it back out the hole it came in. 4: repeat for the the hook side. Its pretty easy once you get the hang of it. If this doesnt help keep asking and Ill give you more detailed instructions later. Semper Fidelis Chestypuller