0
How do you keep the harmonic balancer on a 91 Olds Cutlass Ciera from turning when you try to remove the bolt?
1. Disconnect battery 2. best to use impact wrench with belts on, then loosen bolt but don't take balancer off until you loosen belt. 4. turn crank to compression stroke manually - try like that ...if not, read on 5. fill up one cylinder with oil, replace plug to create hydraulic lock- drain oil when done 6. OR fill cylinder with 1/4 inch nylon rope with piston at Bottom Dead Center, then when you turn crank it will bind up. Back up crank and remove rope when done
What else can I help you with?
Where is the Crank shaft sensor 1989 cutlass ciera?
Behind the harmonic balancer. You will need to remove the right front tire, remove the access panel to the engine (through the wheel well), remove engine belt, remove harmonic balancer & pulley with a puller. Remove & replace crank sensor, align sensor with an alignment tool, replace balancer with an installer tool.. BE VERY careful with the balancer, the backside of it has a hall effect style blades. bending these blades will junk the balancer.
How do you remove the harmonic balancer in a Nissan Maxima?
To remove the harmonic balancer from a Nissan Maxima, first you need to removed the center bolt. After that, you can use a puller to remove the harmonic balancer. Before you do this, make sure you disconnect the battery and remove the drive belts.
How do you remove 327 harmonic balancer?
With a balancer puller tool. With a balancer puller tool.
How to remove crank pulley?
On most newer cars, the crank pulley is one piece with the harmonic balancer.... Remove it with a harmonic balancer puller.
Chevrolet harmonic balancer tool?
The harmonic balancer tool is made especially to remove the balancer. Some stores will loan you the tool with a deposit.
How do you remove harmonic balancer on 2000 cougar?
use a harmonic puller
How do you remove a harmonic balancer on a Chevy Malibu with 3.1?
Go to Autozone and tell them u need a harmonic balancer puller
How do you remove the harmonic balancer on a 1998 saturn sl2?
To remove the harmonic balancer on a 1998 Saturn SL2, you will need to use a harmonic balancer puller tool. First, remove any surrounding components that may impede access. Then, attach the puller to the balancer and use a wrench to slowly tighten the puller until the balancer comes off.
How do you remove a harmonic balancer on a 97 Concorde?
Remove upper core support, remove radiator, remove belts, using a hormonic balancer puller(specific for chrysler) remove balancer.
How do you change harmonic balancer on 1991 buick lesabre?
The flywheel has to be held in place by a holding tool, Remove the mounting bolt, then use a balancer remover to pull the harmonic balancer.
What direction to turn harmonic balancer bolt to remove harmonic balancer?
To remove a harmonic balancer, you typically turn the harmonic balancer bolt counterclockwise (to the left). However, some engines may have a reverse thread, so it's always best to check the specific service manual for your vehicle. Ensure that the engine is securely supported and that you have the right tools for the job.
How do you remove the harmonic balancer on a 1990 Nissan 300ZX?
To remove the harmonic balancer on a 1990 Nissan 300ZX, first disconnect the battery and remove any accessories obstructing access, such as the fan and belts. Use a harmonic balancer puller to ensure safe removal by threading it into the balancer and turning the center bolt to pull it off the crankshaft. Be cautious to support the engine if necessary, and ensure all bolts are properly torqued during reinstallation. Finally, check for any damaged seals or components before reassembly.
