A bad coolant temp sensor disables the fuel pump or at times result to rough engine idle. On a partially defective sensor, it triggers a what it seem on and off operation of the fuel pump specially on an uphill climb or on a heavy car load.
On a Mazda 6 diesel, the coolant temperature sensor is typically located near the engine's thermostat housing or cylinder head. It is usually situated in the cooling system, allowing it to accurately measure the temperature of the coolant as it circulates. Accessing it may require removing some components, depending on the specific model year. Always refer to the vehicle's service manual for precise location and instructions.
The cooling sensor, often referred to as the coolant temperature sensor, on a Mazda 626 is typically located near the engine block, usually on or near the thermostat housing. It is positioned to monitor the temperature of the coolant as it circulates through the engine. In some models, it may also be found near the cylinder head. Always consult the vehicle's service manual for the exact location, as it can vary by model year.
1988 or 1998? either way it is locate on the thermostat housing. on the 1998 model that is at the front of the engine on the left side (as you look at it) on the top some models have one some have two.
Vehicle make, model & engine size needed first.
It depends on which model year / engine. The E46 330i operating coolant temperature is about 97 Celsius.
The number of coolant sensors in a vehicle can vary depending on the make and model. Typically, most vehicles have at least one coolant temperature sensor, which monitors the temperature of the engine coolant. Some vehicles may have additional sensors, such as a low coolant level sensor or multiple temperature sensors for different engine components. Always refer to the specific vehicle's service manual for accurate information.
The Mazda 323 typically requires about 6 to 8 quarts (approximately 5.7 to 7.6 liters) of coolant when performing a full system flush or refill. However, the exact amount can vary based on the specific model year and engine type. It's always best to consult the owner's manual for the precise coolant capacity for your specific vehicle.
The average coolant temperature for a Cadillac should typically range between 190-220 degrees Fahrenheit when the engine is at operating temperature. It's important to refer to the specific model's owner's manual for the exact temperature range.
The coolant capacity of a Mazda 323 typically ranges from about 6.5 to 7.5 quarts (approximately 6 to 7 liters), depending on the specific model year and engine configuration. It's always best to consult the owner’s manual or a service guide for the exact capacity for a particular vehicle to ensure accuracy.
On a 1999 Pontiac Montana, the coolant temperature switch is typically located near the thermostat housing or on the engine block, depending on the specific engine configuration. In many cases, the coolant temperature switch has been replaced by a coolant temperature sensor, which serves a similar purpose by providing temperature readings to the engine control module. If you're troubleshooting temperature issues, it's essential to check for the correct component based on your specific engine model. Always refer to the vehicle's service manual for precise locations and specifications.
The coolant temperature sensor on a Chevy Aveo is typically located near the thermostat housing or on the engine block. It is usually positioned in a way that allows it to measure the temperature of the coolant flowing to and from the engine. For precise location details, it's best to consult the vehicle's service manual or a repair guide specific to your model year.
For the coolant level it is usually located in the coolant reservoir. For the coolant temperature it is usually located on the engine close to the thermostat or on a cylinder head. Need more info like year, make and model to help you more.