I assume that the latch is broken? You can get a stiff wire and poke it in the hole on the right inside section of the handle - hook the release lever and pull down while pulling outward.
If this doesn't work or the hole is blocked by part of the handle, then you'll have to pull the paneling off from the inside. Look on the Toyota Sequoia boards - there are tons of explanations on how to do this and some even provide pictures. You probably will need to replace the rear handle - not that hard a job. The dealer wanted $400; I did it for $15 with an eBay knockoff.
where is the botton to open back door on 2003 toyota sequoia
Hold the tailgate open about half way, release both tailgate straps, lift up and out on passenger side of tailgate, slide tailgate to the right, done.
If the handle is broken, then you'll have to manually open it. If the locking mechanism is frozen, you will have to manually open it. Generally that means pulling the back panel off and pulling the latch cables by hand. Sequoia forums have detailed information on how to remove the rear panel - fairly simple.
The fuse for the clock in a 2002 Toyota Sequoia is located in the engine compartment fuse box. Specifically, it is usually labeled as "ILLUM" or "CLOCK" on the fuse box cover. To access the fuse, open the engine compartment and locate the fuse box, then check the corresponding fuse for any signs of damage or a blown element. If the fuse is blown, replacing it should restore power to the clock.
The horn relay on a 2002 Toyota Sequoia is typically located in the engine compartment fuse box. To access it, open the hood and look for the fuse box near the battery. The relay should be labeled, and you can refer to the diagram on the fuse box cover for its exact position. If you're having trouble, consult the vehicle's manual for more detailed information.
the rod for the door handle is held on with a plastic clip it may have wore out
cant open tailgate
To replace the license plate bulb on a 2002 Toyota Sequoia, first, open the rear hatch and locate the license plate light assembly above the license plate. Use a flathead screwdriver to gently pry off the lens cover. Remove the old bulb by twisting it counterclockwise, then insert the new bulb and reassemble the cover by snapping it back into place. Finally, test the new bulb to ensure it's functioning properly.
Removed the back panel from inside staring from top to bottom of the plastic, and you will be able to open. Then replace the back door handle.
Neither will my tailgate, not sure if it's a fuse or what? Did you ever get yoru tailgate to open? for myself i just bought my rendez vous and all i have is a remote to open the tailgate,if ever i lose that remote im in deep trouble because there no switch or nothing to open it ;-(
Open your tailgate. remove the 2 screws on the inside where your tailgate normallt rests. pull straight out on the bulb. they sometimes break so wear gloves.
use a flat head screwdriver to open the mechanism that is not workin put it in and push backward toward the tailgate