0
To program the remote for a 1998 Acura CL, first, sit in the driver's seat and close all doors. Insert the key into the ignition and turn it to the "On" position without starting the engine, then turn it back to "Off" and remove the key. Within five seconds, insert the key back into the ignition, turn it to "On," then "Off" twice, and finally to "On" again. Press the "Lock" button on the remote within 10 seconds; the door locks should cycle to confirm successful programming. Repeat for additional remotes if needed.
What else can I help you with?
1998 Acura CL 2.3 radio unlock codes?
what is is of radio unlock codes Acura TL 1998
How do you program 98 Acura CL garage door opener?
To program the garage door opener in a 1998 Acura CL, first ensure the vehicle is parked outside the garage with the ignition on. Press and hold the two outer buttons on the HomeLink transmitter until the indicator light begins to flash rapidly. Next, hold the garage door remote control about 1-3 inches away from the HomeLink button you wish to program and press the remote button until the HomeLink light changes from a slow blink to a rapid blink. Finally, press the programmed HomeLink button to test the opener.
How many quarts of oil go in a 1998 Acura CL?
4.2
How do you program keyless remote for 2001 Acura CL?
To program a keyless remote for a 2001 Acura CL, first, enter the vehicle and close all doors. Insert the key into the ignition and turn it to the "On" position (do not start the engine) three times in succession, ending in the "On" position. The door locks will cycle to indicate that the vehicle is in programming mode. Press the lock button on the remote within 5 seconds to program it; the locks will cycle again to confirm successful programming. Repeat for additional remotes, then turn the ignition off to exit programming mode.
Codigo para desbloquear estereo Acura CL de 1998?
como des bloqueo stereo acura
WHAT IS ENGINE OIL CAPACITY FOR 1998 ACURA CL?
For the 2.3 CL, it's 4.5 quarts. For the 3.0 CL, it's 4.6 quarts.
Where is the obd plug in a1998 accura cl 3.0?
The 1998 Acura CL OBD 2 port is on passenger side of console
When was Acura CL created?
Acura CL was created in 1997.
Where is the diagnostics port on a 1998 Acura CL?
It's behind the ash tray on the center console.
Where is the starter on an Acura 1998 3.0 CL?
the same place all starters are located against the flywheel.
The red light on your remote to your alarm is staying on for a Acura CL?
If the red light on your Acura CL's remote is staying on, it typically indicates that the remote is in "programming mode" or that the battery is low. Check the battery and replace it if necessary. If the issue persists, try resetting the remote by removing the battery and pressing any button for a few seconds before reinserting the battery. If these steps do not resolve the issue, consult the vehicle's manual or contact a dealership for further assistance.
How do you change a 98 Acura CL alternator?
how to change alternator in acura 1999 cl
