To pull diagnostic trouble codes (DTCs) from a 1995 Infiniti J30, first locate the diagnostic connector under the driver's side dashboard. Use a jumper wire to connect terminals "E" and "T" on the connector. Turn the ignition key to the "ON" position (without starting the engine), and the check engine light will begin to flash, indicating the codes. Count the flashes to identify the codes, which will be in a two-digit format.
The battery for an 95 Infiniti J30 is 12 Volts.
The diagnostic connector for the 1995 Infiniti J30 is located under the dashboard, near the driver's side, specifically to the left of the steering column. It may be covered by a panel or trim piece that needs to be removed to access the connector. This OBD-I connector allows for diagnostic testing and accessing trouble codes.
Pennzoil 10W-30 or 10W-40.
well...........its just a guess..............but it IS from 1995
Yes you should be able to.
same place you pull the dipstick from....you have to use a funnel
The J30t has the touring alloys, a whale tail, and 4 wheel steering (Hicas system).
need to set base idle and clean fuel injectors
Have airbag checked. Codes can only be "pulled" when the warninglight is illuminated.
Is the timing belt on a j30 infinity run the alternator
It is mounted next to the driver side rear speaker. if you pull your forward trunk panel off you see it.
how many quarts of transmission fluid goes into an 93 infiniti j30