0
1)remove the two Phillips screws on the bottom of the panel. (look up from the floor to see them)
2)lift the panel out from the bottom first and then the top slides slightly down and out.
3)unplug all connections (3 if i remember correctly).
4)unscrew the 4 screws holding in the switch on the back.
5)unscrew the tiny screw in the hole on the bottom of the turn knob.
note: there is a white plastic piece on the side of the switch which can fall off. Mine did, and it took me awhile to find out where it went. Just note where it goes in case you knock it off.
What else can I help you with?
How do you change the headlight switch on 1987 Nissan 300zx?
Remove steering wheel disconnect Quick Connects unscrew switch and pull out put back in same way
How do you replace multifunction switch on a Nissan 300zx?
i have a 300zx Nissan and i need to replace themultifunction switch i don't know how?
What does the lights sensor in the dash mean in a Nissan 300zx 1986?
That light indicates that the headlight switch is in the on position with the engine not running and the drivers side door open.
What could make the headlight's and the wipers work some times and not work other times on a 1984 Nissan 300zx?
I had an 85 same problem with lights had to replace the switch on steering column about 150.00 for part from Nissan
How do you remove the complete headlight on a 90 300zx?
A 1990 300zx headlight is recessed into the bumper. To remove it, first loosen the headlight bracket bolts. Unplug the lights and push the housing outward. Be careful not to ruin the weather stripping for the lights.
Where is the inhibitor switch on a 1990 Nissan 300zx?
it is located on the transmission itself
What is the rubber gasket on the headlight for on a Nissan 300zx?
The rubber gasket on the headlight of a Nissan 300ZX serves as a seal to protect the headlight assembly from moisture, dust, and debris. It helps maintain a proper fit between the headlight and the vehicle, preventing water leaks that could damage the electrical components and reduce visibility. Additionally, it aids in thermal insulation, ensuring optimal performance of the headlight.
Changing headers on a 1994 Nissan 300ZX?
You will have to remove the engine.
Where is the inhibitor switch located on a 1987 Nissan 300ZX?
The inhibitor switch on a 1987 Nissan 300ZX is typically located on the transmission. It is mounted on the transmission case and is connected to the shift lever. This switch is responsible for preventing the engine from starting unless the transmission is in the park or neutral position. To access it, you may need to remove the transmission cover or other components for better visibility.
You just installed a new headlight in your Nissan 300ZX and also checked the fuses but it still will not work What could be the problem?
Check the wires that plug into the light sounds like a bad groung or no power goining to the headlight. If that's not the problem check the dimmer switch.
Where is the ignition switch located on a 1986 Nissan 300ZX?
when you start the car up that's your ignition switch is located...
What does the red on off switch in the center cousel do in a 1987 Nissan 300ZX nonturbo?
On my '86, 300zx NA, the rocker switch on the console turns on the heated outside mirror (drivers side).
