To remove the driver’s side mirror assembly on a 2010 Honda Pilot, first, disconnect the vehicle's battery to avoid any electrical issues. Then, carefully pry off the plastic cover at the base of the mirror to access the mounting screws. Remove the screws using a socket or wrench, disconnect the electrical connector, and gently pull the mirror assembly away from the door. Finally, replace the assembly by reversing the process.
Remove the trim panel and there are screws that hold the mirror on inside the door. Go to this website. It will show how to remove the door panel and the mirror assembly. Only go to step 12. The rest is for installing their mirror. Do the reverse when reinstalling. kwmuth.com
no
You will need to remove the door panel from your 2001 Honda Civic. Remove the site view mirror wiring harness. Remove the side view mirror retaining bolts. Reverse the process to install the new side view mirror.
I HAVE SAME PROBLEM. WHAT DO YOU DO? johnson07b@att.net THANKS, BJ
Remove the wiring harness from the back of the headlight. Remove the headlight assembly bolts. The headlight assembly will come out.
hammer
To remove the headlight assembly from a 2004 Honda Pilot, first, open the hood and locate the screws securing the headlight assembly. Remove these screws, typically found at the top and side of the assembly. Next, gently pull the assembly forward to disconnect it from the clips, and unplug the electrical connector from the back. Finally, take out the assembly completely for replacement or repair.
How do I remove and install transaxle assembly for 2004 Honda odysee
A Honda Civic rear view mirror is held in place by screws. To see the screws remove the plastic cover. Loosen all the screws and the mirror will drop down. Replace with a new unit.
Open the hood to the engine compartment. Remove the headlight wiring harness. Remove the headlight assembly bolts. There are four headlight assembly bolts. The headlight assembly will come out.
No, but you have to remove the wheel assembly and transmission.
i just recently did this and its not easy lol. you have to completely remove the spindle from the car and press the wheel bearing out along with the hub assembly.