answersLogoWhite

0

On either side of the hazard and defroster switches are clips that hold the switch in place. You have to pull them out. You might be able to pry it out using finesse and a thin blade such as is found on a butter knife but the clips must be pressed in to allow you to remove the switches. If you aren't gentle enough, you'll break the switch. When you get the switches out and disconnected, there are two screws straight back towards the firewall which must be removed. Use a bit of rubbery sticky sealant on the tip of a long Phillips screwdriver so the screws don't fall behind the dash. Work the control assembly out by gripping top and bottom.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you remove the governor on a Acura Integra?

You can remove the governor on an acura integra by having the ecu chipped.


How do you remove an axle from a 1994 Acura Integra?

a hammer


How do you remove dashboard in 94 Acura Integra?

Yes


Haw to change light bulbs in climate control panel acura integra 1995 special edition?

When changing the lights on a 1995 Acura Integra remove the dash on the center console and pull it off. Remove all the accessories and reach the old bulbs. Replace the bulbs.


How would the repair of the heater and air conditioning not blowing be made on a 1994 acura integra?

I own a 1994 acura integra and the heater/air conditioning blower is not working, I can not defrost my windows and the heat does not blow. What is wrong and how can the problem be fixed.


How do you replace lower control arm on a 1994 Acura Integra?

To replace the lower control arms on a 1994 Acura Integra safely raise and stabilize the car. Remove the lower ball joints and two bolts that hold the lower control arms to the car. Pull them off. Replace with a new unit.


How do you remove the distributor rotor from a 1994 Acura Integra?

Remove the bolts that hold the distributor cap onto the distributor. Once this is off the rotor can be reached and replaced on a 1994 Acura Integra.


On 1991 acura integra were is idle air control valve located?

The 1991 Acura Integra idle air control valve can be found on the firewall. The valve will be on the drivers side of the firewall.


Where is the 1995 Acura Integra fan switch located?

The fan switch on a 1995 Acura Integra is located on the dashboard. It is a part of the temperature control system.


What do i do if my heater stops blowing air in your 1993 acura integra?

check for a blown fuse that says heater or blower motor


Where is the fuse for cruise control on a 94 acura Integra?

Fuse for cruise control on a 1994 Acura Integra is found in the engine bay fuse box. The fuse is located in the slot labeled CRUISE.


Does a 91 Acura Integra have a b16 engine?

91 acura integra has a b18 91 acura integra has a b18