I just removed mine today 11-06-11. Be very careful when doing this. Take care not to force anything loose or it will break. First you have to use a Phillips head screw driver to remove the fasteners around the bottom of the tail gate to start.
You may need to use a straight edge screw driver to help pry them loose. after you remove the fasteners you can begin to pry the panel loose from the outer skin. Here is where I recommend caution. Pry from top to bottom and then from left to right. A little at a time till you feel sure you can pull it straight away from the metal skin of the door.
I broke the very middle one. You will see that the fasteners are attached to the skin with a metal clip that secures both skin and panel together.
Putting it back together will be easier. Good luck.
A pipe inside the rear hatch has diconnected, simply remove the plastic inner panel inside the hatch and reconnect
you need to remove the inner door panel. Usually pop grommets but may be screwed. That will give you acess to the crank and the inner workings of the door to remove and connect a power window if needed.
To remove the door panel from a 1995 Honda Accord LX sedan the mounting hardware must be unscrewed. Afterwards the mounting clips can be pulled off along with the door panel.
Remove the liftgate inner trim panel.Remove the liftgate inner trim panel.
To remove the rear hatch panel on a 2005 Nissan Pathfinder LE, first, ensure the vehicle is turned off and the hatch is open. Carefully pry off any trim pieces or covers that may be hiding screws, then remove the screws securing the panel. Next, gently pull the panel away from the hatch, being cautious of any clips or wiring connected to it. If needed, disconnect the wiring harness before fully removing the panel.
Need to remove the tailgate inner trim panel on hatch and estate car.The lamp is held on by two clips (estate)or two screws(hatch)the wiring needs a couple of ties undoing to remove the lamp.
remove the inner door panel, you can access the bolts from the inside of the door.
Remove 2 mounting bolts (w/ hatch open) then pull light assm. out and replace bulb. The inner lights require removal of gate's trim panel, remove 4 mounting nuts.
hi hello
The inside door panel cannot be removed; instead, to get to the inner workings of the door remove the OUTER panel. Lift the outer door handle to expose the pins that hold the outer handle to the door mechanism. Then press out the pins and remove the handle. Then remove the screws around the perimeter of the door that hold the outer panel. The panel should lift off, exposing all of the inner workings, then you can verify that the inner panel does NOT come off.
what steps are required to remove the inside door panel on a 1997 Chevy Malibu.
There is an access panel in the car just above the fuel pump. Remove that panel and you can access the pump.