Unlikely, the MK1 is four stud, a mk2 uses 5 stud
Its the mk2 late 1989-1999 Kind regards www.mr2-Ben.co.uk Toyota mr2 mk2 New & Used Spares
Use a flathead and wedge it out
An MR2 MK2 1990
In the MR2 MK2, the ECU (Engine Control Unit) is typically located behind the passenger side dashboard. To access it, you'll need to remove the lower kick panel and possibly the upper dash panel. The ECU is housed in a metal casing, making it a bit challenging to reach, but it's essential for managing the engine's performance and diagnostics.
when sitting in drivers seat, it is in the kick panel near your left foot behind where the front hood latch is and up slightly higher. its a small fuse box, one of 3 on the mr2 mk2
The 3SGTE motor is completely different from the 4AGE or 3A motor, simple answer is no.
probably by removing the plastic cover under the front of the car and reaching in from there
The starter is on the left side (inside) of the engine underneath the exhaust manifold.
Sounds like the speedo cable may have snapped www.mr2-ben.co.uk Toyota mr2 mk2 New & Used parts
On a 2003 Toyota MR2 Spyder, the starter is located on the driver's side of the engine bay, near the rear of the vehicle. Specifically, it is mounted to the transmission bellhousing, making it somewhat accessible from underneath the car. To reach it, you may need to remove some components or panels for better access.
Yes, the mr2 mk3 wheels fit all years 2000 to 2007. They will not fit the mk2 model which has a 4 stud pattern rather than the mk3 5 stud pattern.