YOU don't, unless you wanna remove your glovebox, and most of the dash (no sh*t) just goto car toys and buy the new deck (they install it for free) so it saves YOU the trouble. I think the headlight bulb removal is another pain in my ass with the Mazda 6. should have shopped better. but it is a sweet ride so oh well :)
Remove the decorative stereo cover. Remove the stereo retaining screws. Pull the stereo out and remove the wiring harness and the antenna cable.
To remove the stereo from a 2009 Mazda 6, start by prying off the trim panel surrounding the stereo using a trim removal tool to avoid damage. Once the trim is removed, unscrew the screws securing the stereo to the dashboard. Carefully pull the stereo out and disconnect the wiring harness and antenna cable from the back. Finally, replace the stereo by reversing the steps.
big truck and a chain
i need stereo wiring schematic for 08 mazda 6 non-bose
Mine does, but I can't figure out how to change the stereo to aux mode from fm or cd
To remove the stereo from a 2007 Mazda 6, first disconnect the negative battery cable to ensure safety. Then, use a trim removal tool to gently pry off the dashboard panel surrounding the stereo, being careful not to break any clips. After removing the panel, unscrew the mounting screws securing the stereo, disconnect the wiring harness and antenna, and finally, pull the stereo out of the dashboard. Reverse the process to install a new stereo.
what is an air box
You CAN'T! There's other alternatives but it required some soldering of the internal parts of the stereo. http://www.cushieaudio.com.au/mazda-ipd3.html
Where would the knock sensor be located on a 2004 mazda 6?
Remove the plastic cover on the outside and just pull the bulb out
yes
Most likely it is built into the dash where your stereo controls are. If not Go the the trunk and remove the carpet on the sidewall on the drivers side that is where the actual stereo is.