you have to find your belt tenstioner they are all different but they are fairly simple to adjust loosen too remove belt it should only have one
105kw and they go pretty fast 0-100 on 8.8 sececonds
The tire size for the 1999 Nissan Pulsar typically varies depending on the specific model and trim. However, a common size for many variants is 195/60R15. It's always best to check the owner's manual or the tire placard located on the driver's side door jamb for the accurate tire specifications for a particular vehicle.
On a 1999 Nissan Pulsar, the crank angle sensor is typically located near the crankshaft, often mounted on the engine block or near the timing belt or chain cover. It usually sits close to the front of the engine, where it can accurately detect the position of the crankshaft. The exact location may vary slightly depending on the specific engine type within the Pulsar lineup. Always refer to the vehicle's service manual for precise details.
you have to take the screws out of the long handle then on the arn rest you have plastic screw things that pop in the door all you have to do now is pull the bottem out then work your way up the door panle when you get to the window simply lift up michael
how to remove front rotors on 2003 Nissan fronter 4 wheel drive pick up
In the 1999 Nissan Quest, the CD player is typically located in the center console area, integrated with the radio and cassette player. You can find it just above the climate control settings. If your vehicle is equipped with a factory-installed CD player, it should be easily accessible from the driver's seat.
The 1999 Nissan windshield wiper linkage is held in place by three retaining nuts. Remove the retaining nuts and the linkage will come free. Replace the linkage with new linkage.
In order to remove the dash face plate on a 1999 Nissan Quest, you need to put on the parking brake, shift into a lower, open the ash tray, and remove it. Next, you will need a Phillips screwdriver to take out the screws on the back of the radio, release all the trigger mechanisms attached to the stereo, and then use the screwdriver to remove the mounting bracket.
under the cover in the front, you have to remove the coils in order to get to the plugs the rear is hard to get to sometimes you have to remove the upper intake to get to them good luck
You can find the alternator on the front, right hand side, of your engine. Remove the cables from the alternator. Remove the belt. Remove the retaining nuts. Reverse the process to install the new alternator.
Park in downtown neighborhood with doors unlocked