answersLogoWhite

0

there are clips that hold it in so you have to get a spot that you can pop out the clips than undo the rest

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you remove the dashboard in a Hyundai Accent 1998?

aua cuz


Where do you put the transmission fluid in a 1998 hyundai tiburon?

in the tire!


Is there a drain plug on a 1998 Hyundai Tiburon torque convertor?

No, there is not.


Will a 2003 Hyundai tiburon motor fit in a 1998 tiburon?

de[ends if it is a v6 or a beta i4 engine


What is the bolt pattern for a stock 1998 Hyundai Tiburon?

I believe it is 4 x 114.3


How do you check the transmission fluid on a 1998 Hyundai Tiburon?

were is the dip stick for the trains fluid


Does a 1998 Hyundai Tiburon have an air bag?

YEAH -- two -- one on each side


Where is the fuel filter on a 1998 Hyundai Tiburon?

The fuel filter on the 1998 Tiburon is beside the power brake bootser on the drivers side of the firewall. It is enclosed in a plastic casing and is usually tough to remove - especially if it has never been changed before. You can get a replacement from Hyundai for less than $30 and no, you dont need the copper washers that they try to sell you...Good luck!


Will a 2001 Hyundai tiburon automatic transmission fit a 1998 Hyundai tiburon?

No... 1999 to 2001 will work only for those model years. we tried sticking a 98 into a 2001 and it fits but won't work because of the sensors


Flasher relay location on 1998 Hyundai tiburon?

it is located under the steering wheel column, you have to look for it but its down there


Why is your Hyundai tiburon windshield wiper not moving the wipers?

I have the same exact problem , i have a 1998 tiburon and the wipers are not moving.. i think it might be the wiper motor, I will buy one and see if that's the issue


How do you change a front wheel bearing in a 1998 hyundai tiburon?

To change the front wheel bearing on a 1998 Hyundai Tiburon, start by safely lifting the vehicle and removing the front wheel. Next, detach the brake caliper and rotor to access the wheel hub. Remove the hub assembly by taking out the retaining bolts and using a puller if necessary. Finally, press in the new wheel bearing, reassemble the components in reverse order, and ensure everything is properly torqued before lowering the vehicle.