0
What else can I help you with?
What would cause a 1993 Honda Prelude with automatic transmission to shift hard out of park?
you have to put your foot on the break pedal, to shift out of park its a safety feature
Where is obd connector on 1992 Honda Prelude?
The OBD connector on a 1992 Honda Prelude is located under the dashboard, near the driver's side, typically just above the area where the brake pedal is located. You may need to remove a cover or panel to access it. It's usually a 16-pin connector, which is standard for OBD-I systems.
How do you replace acceletator cable Honda prelude?
To replace the accelerator cable on a Honda Prelude, first, disconnect the negative battery terminal for safety. Remove the engine cover if applicable, then detach the old cable from the throttle body and accelerator pedal by loosening any retaining clips or bolts. Install the new cable by threading it through the same path and securing it to the throttle body and pedal. Finally, test the pedal's operation before reconnecting the battery and ensuring everything is functioning properly.
Why would you have to press brake hard to get from park to drive in a 1995 Honda Prelude with automatic transmission?
It sound like the switch needs to be adjusted down below the brake pedal. Someone thought it might be a solenoid problem? Does that sound right?
Where is the diagnostic port on a 2000 Honda Prelude?
The diagnostic port on a 2000 Honda Prelude is located under the dashboard on the driver's side. Specifically, it is near the steering column, just above the brake pedal. You may need to remove a cover or panel to access it easily. This port is used for connecting a diagnostic scanner to read trouble codes and perform vehicle diagnostics.
Why When I press the gas pedal on my 95 Honda Prelude The Car Turns Off Earlier The Same Day I Was Driving It and It Was Pulling Back As If I Wasn't Pressing The Gas Pedal?
clogged or bad catalitic converter
How do you adjust a hydraulic clutch on a 1990 Honda Prelude?
You can bleed it though if the pedal is just low. Check the master and slave cylinders for leaks too.
Why is the Clutch pedal to floor in my 1990 Honda Prelude?
There is no fluid in the system or master cylinder/slave cylinder failure (hydraulic). Cable streched or broken (if not hydraulic).
Can you change a 3 speed manual in a 1968 Chevy c10 to an automatic?
Yes you can remove a manual transmission and replace it with an automatic. You will need to buy an aftermarket shifter kit of find a shifter for your vehicle from a junk yard. You will also either have to remove the clutch pedal or replace the pedal assembly
Why no brake lights on a 1993 Honda prelude but the running lights stay on all the time.Bulbs are fine .?
The brake lights may not work on a 1993 Honda Prelude if the brake light switch is no longer working. The brake light switch is in the steering column just above where the brake pedal is bolted to it. There is also a chance that a brake light fuse is blown.
What if your clutch pedal isn't working until you pushe it more than halfway in and its hard to downshift 1989 Honda prelude 2.0?
answerchange master cylinder and slave properly then bleed the system properly.
How do you adjust the clutch master cylinder on a Honda Prelude?
To adjust the clutch master cylinder on a Honda Prelude, first, locate the adjustment rod connected to the clutch pedal. You can typically turn the rod to either lengthen or shorten it, ensuring that there is a slight amount of free play (about 1-2 mm) at the top of the pedal's travel. After adjusting, check the clutch engagement point and ensure it operates smoothly without any binding. If necessary, repeat the adjustment until the desired engagement feel is achieved.
