how do you remove the brake light cover on a 1991 gmc tracker? Do you go from the outside or inside?
How do you remove the brake light cover on a ford focus
How do you remove cover to replace brake light on 57 kia Rio
i assume it is the brake light that is inside the car above the parcel shelf. You will need to get a screwdriver and on the underside of the brake light there will to two holes - inside are the screws (they are there), Remove the screws and then carefully lift the plastic cover up and out of the way. Now remove the blown bulb and replace.
This isn't definitive, GM may have come up with a new better idea, but generally there are two ways to change brake lights on any car: from the outside or the inside. From the outside, locate the screws that hold the lens on, remove them, remove the lens cover, change the bulb, and reverse the process. From the inside, locate the back of the light assembly, twist and pull the socket, change the bulb, and replace the socket. Look inside first.
the owners manuel will show you that in the trunk under the light there is two screws. you remove them and lift it from inside the back seat.
access to the rear brake lights is inside the vehicle. Open the rear hatch and on the rear corners of the vehicle, you will see a small cover plate. Take the cover plate off and this will give you access to the lights.
To remove the high-level brake light unit on a 2009 Skoda Fabia estate, start by opening the tailgate. Carefully pry off the plastic cover surrounding the brake light unit using a flat tool to avoid damaging the clips. Once exposed, disconnect the wiring harness and remove the screws or clips securing the brake light unit in place. Finally, gently pull the unit out to complete the removal.
If you're talking about the brake drums, (which need to be removed to inspect or replace the brake shoes inside), they just slide off. First, remove the wheel. Next, wiggle and pull the brake drum (the dinner-plate sized cast-iron bowl-shaped cover) with both hands until it slides off the lugnut studs. Now you can inspect the brake parts.
Remove the cover from around the brake handle by removing the two screw in the lower front and the two bolts inside the center console. Remove the top locking nut from the cable and then turn the other nut clockwise to adjust the brake.
The bulb is probley bad are not grounded, Remove cover and check the bulb and the bulb socket. Cover may be leaking water inside. Reseal if needed.
I have a 95, which is obviously a different body type... but on mine you have to remove the plastic trim along the inside of the trunk behind the brake light assemblies. From there you can remove the plastic clips that hold various parts of it on.