answersLogoWhite

0

To remove the sliding window on a Mazda T3500 bus, first ensure the window is fully closed. Then, locate and remove any screws or clips securing the window frame to the bus body. Carefully slide the window open slightly to access the track, and gently lift it out of the frame. Be cautious to avoid damaging any surrounding components during the process.

User Avatar

AnswerBot

4mo ago

What else can I help you with?

Related Questions

What is the oil capacity of Mazda T3500?

7.5 litres


What is the valve timing on a Mazda t3500 engine?

what causes aknocking sound on mazda T35 engine when its running


What is engine capacity Mazda T3500 diesel 1986?

Engine capacity for T3500 engine is 3.5litres. Officially it is just under this at 3.48litres but is rounded up as always.


What is the towing capacity of Mazda t3500 motorhome?

1400kg towing capacity braked - is the standard online answer but it only specifies Mazda T3500 it doesnt show any differences between any specific models like Motor home or bus ( people carrier )


Where do you fill the clutch fluid on a Mazda T3500 truck?

You don't use clutch fluid for a manual transmission vehicle.


Where is engine number located on 1989 Mazda T3500?

it located where the wipers are just at the corner of the car right and left maybe


What is the valve setting for Mazda SL T3500 engine?

Inlet 28 mm .exhaust 33 mm


How do you set injector pump timing on Mazda t3500?

To set the injector pump timing on a Mazda T3500, you will need to locate the timing marks on the injection pump housing and the engine flywheel. Rotate the engine to the top dead center (TDC) position for the number one cylinder. Align the timing marks on the injection pump with the corresponding marks on the engine flywheel. Use a dial gauge to ensure precise alignment, and tighten the pump mounting bolts once the timing is set correctly.


How do you sewt up Mazda t3500 diesel pump timing?

To set up the timing on a Mazda T3500 diesel pump, first ensure the engine is at TDC (Top Dead Center) on the compression stroke for cylinder one. Remove the timing cover and locate the timing marks on the pump and engine. Align the pump's timing mark with the engine's timing mark, and then secure the pump in place. Finally, recheck the timing by rotating the engine and verifying that the marks remain aligned before reassembling any components.


Where is the engine number located on a 1986 Mazda T3500?

On a 1986 Mazda T3500, the engine number is typically located on the engine block itself. You can usually find it near the front of the engine, often on the driver's side, close to the cylinder head or near the oil filter. It's advisable to clean the area around the engine number to make it more visible for reading. If you have trouble locating it, referring to the vehicle’s service manual can provide specific guidance.


How do you set injector pump timing on Mazda T3500 truck?

To set the injector pump timing on a Mazda T3500 truck, you will need to follow these steps:Locate the timing marks on the flywheel and the injector pump gear.Rotate the engine until the timing marks on the flywheel and the pump gear align.Loosen the injector pump mounting bolts and rotate the pump until the timing mark on the pump gear aligns with the timing mark on the flywheel.Tighten the mounting bolts and recheck the timing marks to make sure they are still aligned.Start the engine and check for proper operation.It is important to note that the procedure may vary depending on the specific model and engine of your Mazda T3500 truck, and you may need to consult the vehicle's service manual for specific instructions. It's also important to make sure to have the right tools and expertise to do this job


What is the maximum load capacity of a madza T3500 truck?

It is 750kg