0
Just yesterday I replaced the door check on my 07 Eclipse GT:
Buy the replacement part (~$35 at the dealer)
Tools needed: 10mm socket (w/ 6" extension - a plus), 10mm open-end or box wrench, phillips screwdriver
Detach door check end from body frame
Remove door panel from door frame, disconnect wire connector from switches
Remove speaker from door frame
Put arm in speaker hole and hold onto door check, do not allow loose parts (if any) to fall into bottom of door, near-impossible to retrieve.
Unbolt door check from door frame, remove from door.
Install in reverse order.
Recommend not to do final tightening of all door check bolts until both ends have been bolted into position, then tighten the four bolts but do not over-tighten as the threads easily strip.
What else can I help you with?
How do you replace S70 Volvo door check strap?
To replace the door check strap on a Volvo S70, first, open the door fully and secure it to prevent it from swinging. Remove the interior door panel to access the check strap by unscrewing any fasteners and carefully prying off the panel. Once exposed, unbolt the old check strap from both the door and the body of the car, then install the new strap by reversing the removal steps. Finally, reattach the door panel and test the door's movement to ensure proper installation.
How do you replace door check strap pin on peugeot 306?
To replace the door check strap pin on a Peugeot 306, start by removing the door trim to access the check strap. Use a suitable tool to carefully pry out the old pin, and then align the new pin with the check strap and door frame. Once the new pin is in place, reassemble the door trim and ensure everything is securely fastened. Finally, test the door's movement to confirm that the replacement was successful.
How do you replace door check strap on Volvo V70?
open the door, remove door trim and the torque screw holding the strap to body, and two nuts holding strap to door and remove door stop from inside door
How do you replace Mercedes c230 hood release strap?
How do u replace a hood release strap on a Mercedes c230
How do you replace front door check strap 2000 c230?
To replace the front door check strap on a 2000 Mercedes-Benz C230, first, open the door fully and support it to prevent it from moving. Remove the interior door panel by unscrewing any visible screws and gently prying it away from the door frame. Locate the check strap, typically secured by bolts on both the door and the body of the car, and remove these bolts. Install the new check strap by reversing the removal process, ensuring all connections are tight before reattaching the door panel.
How do you replace a door check strap on Saturn L100?
This is rather simple actually. You light the entire car on fire! Hope this helps.
How can I replace the sliding sternum strap on my backpack?
To replace the sliding sternum strap on your backpack, first locate the attachment points on both sides of the strap. Then, carefully remove the old strap by detaching it from these points. Next, thread the new strap through the attachment points and adjust it to your desired length. Finally, secure the strap in place by fastening it securely.
How can I replace the sternum strap on my backpack?
To replace the sternum strap on your backpack, first locate the attachment points on the shoulder straps. Then, thread the strap through the attachment points and adjust it to your desired height and tightness. Make sure the strap is securely fastened before using your backpack.
Is the Mitsubishi cars are good cars?
there good if you strap 15 canisters of propane to it and then throw a baby at the propane canister
How do you replace the pull down strap on the 2003 trailblazer?
To replace the pull-down strap on a 2003 Trailblazer, first, remove the interior trim panel where the strap is located by unscrewing any fasteners and gently prying it off. Once the panel is removed, locate the old strap, detach it from its mounting points, and replace it with the new strap by securing it in the same positions. Finally, reattach the trim panel by aligning it properly and fastening it back in place. Make sure everything is securely fitted before closing the vehicle.
Can a low battery make trying to crank a car seem like its the starter?
A low battery can make the starter crank slowly. Another thing that can cause this is bad grounding. Check the ground strap(s) from your motor to your chasis. Unfasten it at each end and clean the connectors and the area where the strap connects. Make sure the strap(s) are not overly frayed. If it is replace it.
If a fuel strap breaks on a 2000 Dodge Intrepid do they need to be replaced?
Yes you need to at least replace the one that is broken and check out the other one and see that it might need to be replaced!
