answersLogoWhite

0

To replace the EGR valve on a 2002 Mazda Protege, first, disconnect the negative battery terminal to ensure safety. Remove the EGR valve by unscrewing the bolts that secure it to the intake manifold, and detach any vacuum hoses connected to it. Install the new EGR valve by reversing the removal process, ensuring all connections are secure and using a new gasket if necessary. Finally, reconnect the battery and start the engine to check for proper operation.

User Avatar

AnswerBot

4d ago

What else can I help you with?

Related Questions

How much does it cost to replace an EGR valve?

how much does it cost to replace to egr valve on the 2002 mazda protege


2002 Mazda protege 5 alternator belt removal?

how do u replace alternator belt on 2002 mazda protege 5 stationwagon


How much does it cost to replace the fan belt in a Mazda Protege?

I just replaced my fan belts on a 2002 Mazda Protege. It came out to a little over $200. I took my car to a Mazda dealership.


Would the headlights on a Mazda Protege 2002 fit the Mazda Protege 5 2002?

Yes they will fit. There is not a difference in part number for a protege or protege5.


Where is the ignition coil on a 2002 Mazda protege?

Where is the igniyion coil on a2002 mazda protege


Where is the belt tensioner for a 2002 Mazda Protege?

in your face :)


Will body kits for a 2002-2003 Mazda Protege fit a 2000 Mazda Protege?

no it will not fit.it is not the same lenght and the same height


WHERE IS the pulse generator in a 2002 Mazda Protege?

The pulse generator on a 2002 Mazda Protege is located on the top of the transmission. The pulse generator can be purchased at any auto parts store such as NAPA.


Does Mazda have front wheel drive vehicles?

does a 2002 mazda protege have a front wheel drive


What weight oil does a 2002 Mazda Protege 5 take?

For a 2002 Mazda Protege 5, the recommended oil is a 10w 30. 5w30 is recommended in temps below 30 degrees f.


Where is the EGR valve on a 2002 Mazda Protege?

I own a 2002 Mazda Protege5 with the FS2.0 Motor. The EGR Valve is located below the throttle-body. You must take off the Intake tube to get a good view of it. To replace it I think you might have to take off the throttle-body, but I'm not sure about that...(yet) NOTE: Mazda put out a technical note stating that "if your car has sat for a long time, the egr valve could be damaged by moisture (rain) and will need to be replaced". My 2002 Protege sat for 3 weeks and the rain caused this exact issue and had to be replaced. How did I know? The engine light came on (after never coming on) and the car had an extremely rough idle. Total cost was ~$400 (ouch).


What is the wheel size bolt pattern and offset for the 2002 Mazda Protege?

5X114.3