regards
gl347CANADA
If its the bulb you have to unscrew the light cover and pull out the old bulb and put the new one in.Then screw the cover back on.
open the hood unplug the bulb from the back of the light assembly and un do the metal clip, pull bulb out of replace with a new one and reinstall
If you mean just the bulb, they are accessed from the trunk. Pull the carpet away from the back of the car and untwist the bulb holder. Replace the bulb and screw the holder back in.
When you replace the brake light bulb on your Rodeo, be careful not to touch the bulb directly with your fingers - the oil from your skin will cause the area that you touched to burn hotter than the rest of the bulb, which causes the bulb to burn out quicker.If you are going to replace a bulb in your cluster, it is a good idea to replace all of them. Not only will the lights on your Rodeo be brighter, you decrease the likelihood you will need to change any of the bulbs again in the near future. A burnt out bulb in the taillight cluster of your Rodeo is an excuse for a police officer to pull you over. Check your bulbs frequently and change burnt bulbs promptly.
1995 geo trunk lid bulb
pull the complete headlight assembly out and then you can get to the build in the back of the headlight.
you have to take the brake light out of the housing and then twist the amber bulb out
There is a connector sticking out the back side of the bulb. Turn that connector about 10 - 20 degrees to the left and pull out. This will expose the halogen bulb.
To change the ashtray bulb on a 1995 Toyota RAV4, first, remove the ashtray by pulling it out of the console. Next, locate the bulb socket at the back of the ashtray; twist it counterclockwise to remove the old bulb. Replace it with a new bulb, ensuring it is securely in place, and then reinsert the ashtray back into the console. Test the new bulb to ensure it lights up properly.
== ==
To replace the bulb in the gauge cluster of a 1995 Toyota Previa, first disconnect the negative battery terminal for safety. Remove the dashboard trim and unscrew the gauge cluster from its mounting. Carefully pull the gauge cluster out and locate the burnt-out bulb; twist it counterclockwise to remove it and replace it with a new bulb. Reassemble the gauge cluster, secure it back in place, and reconnect the battery.
To change the brake light bulb on a 2003 Isuzu Rodeo, first, open the rear hatch and locate the tail light assembly. Remove the screws or clips securing the assembly, then gently pull it out to access the bulb socket. Twist the bulb socket counterclockwise to remove it, replace the old bulb with a new one, and reassemble by reversing the steps. Make sure to test the new bulb before securing everything back in place.