Resistor is located behind glove box. Remove 2 screw at bottom of glove box which attach hinges. Glove box comes right out. The resistor will be directly behind glove box. It will have a plug and 2 screws which hold it in place. Remove plug unscrew and pull out. Install in reverse order.
where is the heater blower resistor in a 2003 Honda element
The resistor block for the blower motor on a 1995 Honda Passport is typically located under the dashboard on the passenger side, near the blower motor itself. It is often mounted directly to the HVAC housing. To access it, you may need to remove the lower dash panel or cover for better visibility and reach.
To replace the blower motor resistor in a 2004 Honda Pilot, first, disconnect the negative battery cable for safety. Then, locate the blower motor resistor, which is typically found under the dashboard on the passenger side, near the blower motor. Remove the screws securing the resistor, disconnect the electrical connector, and then replace it with the new component. Finally, reassemble everything and reconnect the battery.
The Resistor is located on the outside of the blower motor. Have to remove the blower from under the glovebox to get to it. The Resistor is located on the outside of the blower motor. Have to remove the blower from under the glovebox to get to it.
The 1991 Honda accord blower motor resistor is located on the firewall in the engine compartment. The blower motor resistor will be on the passenger side of the firewall.
Sounds like you need to replace your blower motor resistor.
The blower motor resistor on a Honda Odyssey is located under the dash of the passenger's side towards the front. The resistor helps to the air conditioner blow cold air.
the blower motor resistor should be behind the glove box. just unscrew the two screws and that should be it.
Buy a Toyota
Blown fuse, defective blower motor, or defective resistor pack.
It is located on the blower motor housing and is white in color. You have to take the blower motor assembly out as far as I know to get to it.
if it doesnt work on 1 and 2 it could be a blower motor resistor but if it doesnt work at all check the fuses, relay and check voltage if it reads 12 v replace the motor