To replace the front fender on a 2002 Chevrolet Cavalier, first, disconnect the battery and remove any trim pieces or components obstructing access, such as the wheel well liner and front bumper if necessary. Unscrew the bolts securing the fender to the body, typically found near the hood and along the side. Carefully pull the fender away from the body and detach any attached components, like the turn signal light. Align the new fender and secure it with the bolts, then reassemble any removed parts and reconnect the battery.
They were only put two places depending on the model. Right front fender and next to the fuel tank.
It is under the passengers front fender you will need to remove the wheel first.
How do you remove and replace wiper switch on 2002 Chevy Cavalier
To remove the front fenders on a 2002 Chevrolet Cavalier, first, you'll need to disconnect the battery and remove any trim pieces or screws that may be securing the fender. Typically, you'll find bolts along the top edge, inside the wheel well, and along the bottom of the fender. After removing these fasteners, carefully pull the fender away from the body, ensuring you don't damage any clips or wiring. Finally, repeat the process on the other side if needed.
How do you replace a turn signal bulb in a 1998 cavalier
To replace the thermostat on a 2002 Cavalier 22 Ecotec, drain the radiator and remove the upper hose assembly. Replace the thermostat and refill the radiator.
Under the left front fender, in front of the tire. You will have to remove the inner fender liner.
The passenger front wheel needs to be removed for access. The TCC is on the side of the transmission behind the kick-down linkage.
It is important to know the cost of replacing parts on a car. For a 2002 Chevy Cavalier 2.2 it will cost between $200-$400 to replace the struts, is a person is doing it themselves.
driver front fender inside
You can replace the dome light bulb in a 2002 Chevy Cavalier by first prying the dome light cover off of the light. Then, remove the bulb and replace it by twisting the bulb from the socket.
you need to remove the headlight and turn signal lens as a assembly , usually one bolt on top of radiator support , and then the headlight unit has a snap lock onto the fender ,