(1) Open the hood (2) Reach behind the headlight assembly and unlplug the electrical connector, then remove the rubber boot (3) Release the bulb holder retaining clip, then pull the lamp assembly out of the headlight housing. Installation is the reverse of removal. Use caution handling halogen bulbs - especially the new one. Grasp it by the base only - avoid touching the glass bulb with your bare fingers.
Honda didn't start making the CR-V until 1997. Sorry.
You pop the hood take and reach behind the headlight and pull off the bulb cover then pull the bulb out and put the new one in.
== ==
drop the bumper and take the headlight housing out
9003 or H4, same bulb.
call macgyver
To change the headlight on a 1985 Honda Spree scooter remove the headlight housing. The scooter headlight will be mounting on the rear of the housing. Remove it and replace the bulb.
Replacing a headlight bulb on a Honda Passport is very easy to do. The hood will need to be opened to change the bulb. The old bulb can be pulled off by using the connector and the new one put in. No tools are required.
You replace the bulb the same as a 1998, which is answered further down the page.
To replace the headlight on a Honda Ridgeline, first, open the hood and locate the headlight assembly. Remove the screws or clips securing the assembly, then gently pull it out from the vehicle. Disconnect the electrical connector from the back of the headlight bulb, replace the bulb with a new one, and reconnect the electrical connector. Finally, reinsert the headlight assembly and secure it with the screws or clips.
The headlight is an assembly. To replace the headlight, you remove the bulb from the back side. It is a halogen bulb, so do not touch with bare hards before installing.
To replace the headlight bulb on a Honda Fit, first, open the hood and locate the back of the headlight assembly. Disconnect the power connector and remove the rubber cover, then twist the old bulb counterclockwise to release it. Insert the new bulb into the socket, ensuring not to touch the glass, and then reverse the steps to reassemble. Finally, test the new bulb to ensure it works properly.