0
Tools you will need: ratchet/wrench for nuts
You MAY need the above tools for replacing the right headlight as the battery may be in the way. Otherwise, no tools are required to replace the bulbs. To do this begin by taking the battery out by removing the negative connection first and then the positive. Remove the handle on top that keeps the battery in place by unscrewing the right long screw and loosening the left screw. The left one does not need to come out all of the way but the right one will in order to remove the battery. Now the battery is removed.
Now that you have enough room for the right headlight you can begin the procedure. You will see a wire going to your headlight. This is a plug that plugs directly into your light bulb. Remove the plug by pulling the opposite direction the bulb is facing. Most cars have a plug that you pull DOWN to remove but this isn't the case for the Passport. Pull away from the light which should be the opposite direction the bulb is facing.
You will now see 3 prongs sticking out of the rubber gasket surrounding it. This rubber gasket can be removed by just pulling it out of the opening by pulling it the opposite direction again much like the light bulb plug. Note that the gasket may be difficult to pull out. Pull by the two rubber ends that you see on the rubber gasket and wiggle it out to where it is lossened. Eventually you will be able to take the whole gasket out.
With the gasket removed you can now see the whole light bulb within the headlight. The headlight is held in there with some kind of clip mechanism that "locks" within a hook. All you have to do is push the clip inward (toward the light bulb) and push it up. This clip should then open up like a door and your light bulb is ready for removal.
Removing the lightbulb is simple. Just pull it straight out. No twisting or turning or anything which is very common amongst other headlight fixtures (especially blinkers). Now put in your new bulbs and repeat the above steps in reverse order.
Repeat the same steps for the left headlight. The only difference is that you will not need to take out a battery, but the air filter valve is slightly in the way. It is possible to change the bulb without removing any of this stuff.
What else can I help you with?
How do you remove the headlamp assembly to replace the bulb on a 95 Honda Passport?
To change the headlight bulb you do not need to remove the headlamp assembly. Pop the hood and behind the assembly is access to the light bulb, just unclip it and carefully pull it out from the hole. Then you can remove the old bulb and put the new one in. Don't touch the light bulb! It won't work if you do.
How do you replace the headlamp on a Honda metropolitan?
to remove the bulb simply take the four screws that attach the front assembly and it will give you access to the bulb.
How do you replace a headlight bulb in a Honda Passport?
Replacing a headlight bulb on a Honda Passport is very easy to do. The hood will need to be opened to change the bulb. The old bulb can be pulled off by using the connector and the new one put in. No tools are required.
How do you change brake light bulb on 1999 Honda Passport?
To change the brake light bulb on a 1999 Honda Passport find the light housing located in the trunk. Find the plastic covers for the lights and remove them. Pull the bulbs out carefully and replace them.
Replace headlamp on 2002 Honda CR-V?
Gain access to the rear of the headlight housing. Remove the weatherproof rubber protective boot and remove the headlight bulb socket. Replace bulb and re-install in reverse order.
How do you replace headlamp bulb on 2008 Kia Amanti?
To replace the headlamp bulb on a 2008 Kia Amanti, first, open the hood and locate the back of the headlamp assembly. Disconnect the electrical connector from the bulb and remove the retaining clip or twist the bulb socket counterclockwise to release it. Replace the old bulb with a new one, ensuring not to touch the glass with your fingers, and then reassemble by reversing the steps. Finally, test the headlamp to ensure it is functioning properly.
How do you replace the light in the clock in a 1999 Honda Passport?
To replace the clock light in a 1999 Honda Passport, first, disconnect the vehicle's battery to ensure safety. Remove the clock assembly by carefully prying it out of the dashboard. Once removed, locate the bulb socket at the back of the clock, twist it counterclockwise to remove the old bulb, and then replace it with a new bulb of the same type. Reassemble the clock and reconnect the battery to test the new light.
How do you replace headlamp bulb on an Audi a6 2008 model?
with your hands ?
How do you replace the headlamp bulb in a Mercedes A140?
ask someone else to do it
How do you replace a 2007 Nissan Murano headlamp bulb?
To replace a headlamp bulb on a 2007 Nissan Murano, first, turn off the vehicle and open the hood. Locate the back of the headlamp assembly, then remove the electrical connector by pulling it straight off. Twist the bulb socket counterclockwise to release it, then pull out the old bulb and replace it with a new one, taking care not to touch the glass. Reinsert the bulb socket, reconnect the electrical connector, and test the headlamp before closing the hood.
How do you replace a headlamp bulb on a 2006 dodge charger?
1/4 turn to release the old bulb.
How do you replace Honda taillight bulb?
how do you replace a taillight on a Honda 2002 Civic?
