To replace the headlight housing on a 2004 Subaru Impreza Outback, first, ensure the vehicle is turned off and the keys are removed. Open the hood and remove the clips or screws securing the headlight assembly; you may need to remove the grille for better access. Disconnect the electrical connector from the back of the headlight and carefully pull the assembly out. Install the new headlight housing by reversing the steps: connect the wiring, secure it in place, and reattach any parts you removed.
See *Headlight* under Maintenance and Service - Replacing Bulbs, in your "Owner's Manual" (Removing the Headlight Housing Assembly makes life a lot easier).....
To replace the low beam headlight on a 2007 Subaru Outback, first, open the hood and locate the headlight assembly. Remove the plastic cover on the back of the headlight housing by twisting it counterclockwise. Disconnect the electrical connector from the bulb and remove the old bulb by twisting it counterclockwise. Insert the new bulb, reconnect the electrical connector, and replace the plastic cover, ensuring it is secure.
To change the headlight on a 1985 Honda Spree scooter remove the headlight housing. The scooter headlight will be mounting on the rear of the housing. Remove it and replace the bulb.
drop the bumper and take the headlight housing out
See "Headlight" on page 52 of chapter 11 "Maintenance and Service" in your "OWNER'S MANUAL".....
# Remove the front bumper cover # Remove the upper headlight housing mounting bolt and pushpin # Remove the lower headlight housing mounting bolts # Pull out the headlight housing assembly and disconnect the electrical connector
Each type of vehicle has a unique design to its headlight assembly. Some have the headlight and emergencey lights in one housing others have them seperated.
To replace the left front headlight on a 2006 Subaru Outback, first, open the hood and locate the back of the headlight assembly. Disconnect the wiring harness by squeezing the tabs and pulling it off. Remove the rubber cover, then twist and pull out the old bulb. Insert the new bulb without touching the glass, replace the rubber cover, and reconnect the wiring harness before testing the new headlight.
To replace the headlight housing on a 2003 Nissan Xterra, first, disconnect the negative battery terminal to ensure safety. Remove the screws or bolts securing the headlight assembly, usually located at the top and side of the housing. Gently pull the assembly forward, disconnect the wiring harness, and then remove the old housing. Install the new headlight housing by reversing these steps, ensuring all connections are secure before reconnecting the battery.
To replace the headlight housing on a 2001 Toyota Previa, first, disconnect the battery to ensure safety. Remove the screws or bolts securing the headlight assembly, typically located at the top and side of the housing. Carefully pull the assembly forward, disconnect the wiring harness, and replace it with the new housing. Reconnect the wiring, secure the new assembly with screws or bolts, and reconnect the battery to complete the installation.
Where the lens meets the housing there is a seal, just replace it.
Headlight Bulb Replacement * If your going to replace the left hand light bulb remove the air filter housing * Disconnect the electrical connector unless replacing the headlight housing * Rotate the bulb holder counterclockwise and pull it out the bulb and holder assembly Headlight Housing Replacement * Remove the front bumper cover * Remove the upper headlight housing mounting bolt and pushpin * Remove the lower headlight housing mounting bolts * Pull out the headlight housing assembly and disconnect the electrical connector