To replace the HID bulb and ballast on a 2001 Lexus ES300, first, disconnect the negative battery terminal to ensure safety. Remove the headlight assembly by unscrewing the bolts and gently pulling it out. Once the assembly is accessible, unplug the old ballast and bulb; then, install the new ballast and bulb, ensuring they are securely connected. Finally, reassemble the headlight assembly, reconnect the battery, and test the new components.
No , the 3.0 liter V6 engine in a 2001 Lexus ES300 is not an interference engine According to the Gates website ( they make timing belts etc. )
open the hood , its located infront of radiator feedingintothe exaust.
Well, darling, the fuel pump on a 2001 Lexus ES300 is located inside the fuel tank. So, if you're feeling adventurous and want to replace it yourself, get ready to drop that tank like it's hot. Just make sure you disconnect the battery first, unless you're into fireworks.
The 2001 Lexus ES300 uses the 1MZ-FE Toyota V6 engine, which has a timing belt.
In the 2001 Lexus ES300, the AC relay is located in the engine compartment fuse box. To access it, open the hood and find the fuse box near the driver's side. The relay is typically labeled, so check the diagram on the cover of the fuse box for identification. If you need to replace it, ensure the vehicle is off and take proper safety precautions.
go to this site www.mkiv.com-techarticles-spark_plugs-na-6.jpg
It should be right under the exhaust manifold and in front of the radiator. From the front view its in the middle of the engine.
I have a 2001 es and it is in the back between the engine and firewall, down low and you can get to it from the drivers side (not easy to get out).
I want to know
should be on top of valve cover This picture will help you find the PCV valve http://www.clublexus.com/forums/es300-and-es330-forum/418700-2001-lexus-es300-pcv-where-is-it.html What you really need to know is that if your engine has been desludged the L shaped plastic PCV valve would have been replaced with the metallic, straight screw in PCV valve first introduced in 2002.
The labor cost should be around $120 dollars. Hopefully you can get a couple of estimates and go with the cheapest.
I had to pull off the front bumper to replace the ballast and high and low beam bulbs. that's the only way that I know. I had to do this 2 times when the other bulb went out.If the bulb you replace does not work then it might be the ballast.