0
Wait until the engine cools down. Put your car in parking position, jack it up. Disconnect the battery. Make sure that it's safe to stay under the car. You can find the sensor the side of engine facing the firewall. The sensor has harness with only one wire connected to it. Disconnect the sensor remove the sensor. One some models the coolant must drained too, I'm not sure which you have. If your sensor is in contact with coolant you will have to put some sealant on the sensor's thread. After that tighten it (I thinkg it's about 42 N*m). Connect the harness, remove the jacks. Connect the battery, have a test drive.
What else can I help you with?
How do you fix knock sensor on 1996 Toyota Camry v6 le?
replace it.
Where is the knock sensor for a 2001 Toyota Camry?
Knock sensor is attached to the engine side facing the firewall. It's not easy to reach.
Where 2000 Toyota Camry v6 knock sensor location?
In a 2000 Toyota Camry with a V6 engine, the knock sensor is located on the engine block, specifically on the rear side of the engine. You can find it near the intake manifold, below the throttle body. To access it, you may need to remove some components for better visibility and clearance. Make sure to disconnect the battery before attempting to replace the knock sensor.
Where is the knock sensor located 1998 Toyota Camry?
Knock sensor is located in the wall of the engine block facing the firewall. You have lift the car if you want to reach it.
Where is 1992 Toyota Camry knock sensor located?
It should be in the side of the engine facing the firewall.
How do you replace knock sensor Toyota 2000 Avalon?
Open the hood
Where is located the knock sensor on the Toyota Camry 1996 LE?
It should be on the back side engine. The side which is facing the firewall.
What is a shape of 97toyota Camry knok sensor?
Check this out: http://cgi.ebay.com/ebaymotors/91-94-95-96-97-98-99-Toyota-Camry-Celica-Knock-Sensor_W0QQcmdZViewItemQQhashZitem51914a26aeQQitemZ350329906862QQptZMotorsQ5fCarQ5fTruckQ5fPartsQ5fAccessories
How do you find knock sensor on 97toyota Camry?
Knock sensor is located on the side of the engine facing the firewall. There is only one sensor at that side.
Where is knock sensor on 95 5.0?
where is the knock sensor on a 95 Toyota t100 v6
How do you replace a knock sensor Toyota t 100?
To replace the knock sensor on a Toyota T-100, first disconnect the negative battery terminal to ensure safety. Then, locate the knock sensor, typically found on the engine block, and remove any necessary components blocking access. Unscrew the old sensor using a socket wrench, install the new sensor, and reconnect the wiring. Finally, reassemble any removed parts and reconnect the battery.
How do you replace the knock sensor on a 1989 Toyota supra turbo?
the knock sensor is located on the driver side of the engine right under the intake it is about 1 in. it is connected so you will have to unplug it and then just screw it off
