how to replace the license plate bulb on a 2004 Honda cr-v
Remove the plastic cover on the outside and just pull the bulb out
To replace the license plate light bulb on a 2004 Yukon, first, open the rear hatch and locate the license plate light assembly. Use a flathead screwdriver to gently pry off the light cover or twist the assembly counterclockwise to remove it. Take out the old bulb by pulling it straight out, then insert the new bulb into the socket. Finally, reattach the light assembly and cover, ensuring it’s securely in place.
Remove the screws from the lens covering the bulb, pull out the bulb and replace it.
To replace the license plate lights on a 2004 Ford Freestar, first, open the rear hatch. Locate the license plate light assembly, which is usually secured by a small screw or clips. Remove the assembly, disconnect the old bulb, and replace it with a new one. Finally, reattach the assembly and test the lights to ensure they are working properly.
To replace the license plate bulb on a 2004 Cadillac DTS, first, open the trunk and locate the license plate light assembly. Use a flathead screwdriver or a similar tool to gently pry off the lens cover. Remove the old bulb by twisting it counterclockwise, then insert the new bulb and reattach the lens cover. Finally, close the trunk and test the new bulb to ensure it works properly.
=== ===
Oldsmobile stopped making Alero in 2004 and GM stopped making Oldsmobile in 2004, so some mistake here?
You must remove the entire tailight panel - remove trunk liner and the recessed nuts.
I have a 94 not sure if they are the same but behind the license plate was mine Good luck Answer Improvement (Sept 5. 2010) Remove 4 license plate screws and licence plate Remove 4 hex head screws that hold the license plate/backup light assembly Rotate the license plate/backup light assembly around 180 degrees so you can get to the light bulb holders Carefully turn bulb holders 1/4 and remove bulb holder Carefully remove old bulb and replace with new bulb (#194) Reverse these step to reassemble
To replace the license plate bulb on a 2002 Toyota Sequoia, first, open the rear hatch and locate the license plate light assembly above the license plate. Use a flathead screwdriver to gently pry off the lens cover. Remove the old bulb by twisting it counterclockwise, then insert the new bulb and reassemble the cover by snapping it back into place. Finally, test the new bulb to ensure it's functioning properly.
You need to unscrew the whole cover panel for license plate.